Table of Contents
Advertisement
Quick Links
Installation and Operating Manual
Info Panel Pro
Info Panel Pro 24 V
Please read the mounting instructions and operating manual including the safety regulations
completely prior to starting connection and start-up.
Centralized Control and Information Unit for Camper and Boat, Functional Features:
Digital Voltage Display for Starter Battery and Board Battery
Tank Displays for Fresh Water Tanks, Sewage Water Tanks and Feces Tanks (Level Measuring)
Pump Main Switch with LED Pilot Lamp (Water Pump)
Battery Main Switch with LED Pilot Lamp (Equipment-on Check)
Installation:
Choose a well visible and easily accessible location in the living area for installation of the unit. The installation place in the
front panel of the furniture should be chosen in such a way that the contrast of the display be not hindered (sun light).
The small mounting depth of only 12 mm of the electronic system allows flush mounting into commercial furniture boards
to ensure, that an optimum installation place can always be chosen without losing precious storage space.
The clear opening of the furniture cutout should be slightly larger than the assembly dimensions of 176 x 43 mm
to ensure safe alignment of the unit's front panel. Use the delivered drilling jig for alignment.
The rear cutout opening should be covered with electrically nonconducting material (e. g. plastic plate, poplar
plywood, or similar material) to ensure full utilization of the storage space, which might be located behind
Make all electric connections, place the Info Panel Pro centrically in the cutout and use the delivered screws for fastening.
No. 5330
12 V
No. 6330
24 V
Advertisement
Table of Contents
Related Manuals for Votronic Info Panel Pro
Summary of Contents for Votronic Info Panel Pro
- Page 1 The rear cutout opening should be covered with electrically nonconducting material (e. g. plastic plate, poplar plywood, or similar material) to ensure full utilization of the storage space, which might be located behind Make all electric connections, place the Info Panel Pro centrically in the cutout and use the delivered screws for fastening.
-
Page 2: Switch Functions
Always disconnect the power supply to the battery prior to working on the electric system to avoid short-circuits! The Info Panel Pro is connected prior to the final installation. Therefore, the length of the connection cable should be sufficient, in order to facilitate connection and installation of the display unit. It is, however, recommendable to use connection cables of different colours to avoid malfunctions due to mixed up connections. - Page 3 Battery Protector 100 (12 V, to 100 A load current), order No. 3078. It can also be used as efficient, remote-controlled main-switch. For this purpose, connect terminal “8” of the Info Panel Pro to the “Sense +” cable of the battery protector. Refer also to its operating manual, paragraph “Remote Control”.
- Page 4 Level measurement requires installation of a tank transmitter (measuring sensor) at each tank, which must be connected to the Info Panel Pro via three cables or two cables (as well as ground/battery minus). Required Measuring Sensors (1 each Tank, for 12 V and 24 V) Selection acc.
- Page 5 We do not assume any liability for any damage resulting hereof. The liability exclusion is extended to any service being executed by third, which has not been ordered by us in writing. Service is to be effected exclusively by VOTRONIC Lauterbach.
- Page 6 - 6 - Connection Plan Info Panel Pro (Rear View):...
- Page 7 - 7 -...
- Page 8 - 1 Pc. Mounting Instructions and Operating Manual - 1 Pc. Drilling Jig If VOTRONIC units are used in combination with other products, faultless operation cannot be guaranteed! Subject to misprints, errors and technical modification without notice. All rights reserved, particularly the right of reproduction. Copyright VOTRONIC 04/18.
Need help?
Do you have a question about the Info Panel Pro and is the answer not in the manual?
Questions and answers