Fleetworks FLTW-7632 Installation Instructions

Grand Cherokee, Dodge Durango, Dodge Caravan Factory Display Radio
Camera
(Kit # FLTW-7632)
Applications: 2011 – current Chrysler Town & Country (RBZ, RHB, RER, REZ, RBZ, REW radios)
2011 – current Dodge Durango (RHR, RHB, RHZ, RHP, 8.4" radios)
2011 – current Dodge Grand Caravan (RBZ, RHB, RER, REZ, RBZ, REW radios)
2011 – current Dodge Ram Tradesman (RBZ, RHB, RER, REZ, RBZ, REW radios)
2008 – 2010 Jeep Commander (430, 730 radios)
2008 – current Jeep Grand Cherokee (430, 730, RHR, RHB, RB2, RHP, 8.4" radios)
Please read thoroughly before starting installation and check that kit contents are complete.
Items Included in the Kit:
Camera
Hole Saw for camera mount
Chassis Harness
Power Harness
Display Harness with 22-pin connector
Loose red and black wires (if needed)
These Instructions with Template

Safety Precautions:

• Work in well ventilated area that is clear of obstructions.
• Secure vehicle with tire chucks in both front and rear of tires.
• Turn vehicle accessories OFF and ensure ignition key is in OFF position.
• Wear safety goggles and snug fitting clothes.
• Use tools only for their intended purpose and which are in good repair.
• Only perform this task if confidence, skill, and physical ability permit.
NOTE: We strive to provide accurate and up-to-date installation instructions.
FLTW-7632 Instructions 9-1-15.doc
NOTE: Requires Chrysler/Dodge dealer to activate; see below
IMPORTANT: Use of this camera with
the factory display requires activation
by a Chrysler/Dodge dealer. See below
for Dealer Programming Instructions.
If possible, have the dealer "enable"
the camera option prior to installation.
Page 1 of 4
INSTALLATION I NSTRUCTIONS
Tools & Supplies Needed:
Dealer Programmer Tool
Phillips Screwdriver
Center Punch
1/4'' Drill Bit (if needed)
Power Drill
Wire Ties
Electrical Tape or Heat Shrink Tubing
Plastic Trim Removal Tool
Soldering Iron & Solder
T-taps (optional)
Small grommet or Silicone (If needed)
Vehicle service manual (If needed)
(Recommended)