Page 2
Table of Contents 1. Unpacking and Checking Equipment 2. Operation Instructions 3. FCC Information 4. FCC Label Information...
Page 3
1. Unpacking and Checking Equipment Carefully unpack the equipment and its accessories. 1). Remote controller 2). Base communication module 3). Main controller 4). kinds of Harness Assembly 5). Shock sensor 2. Operation Instructions 2-1. ARMING The car alarm system checks the intrusion into the car in the arm mode (shock &...
“NO CHIRP MODE”, the car acts the same way above, but without chirp. 2-2-2. The car memorizes the status of intrusion ( door open )in the arm mode and alerts it when the car is disarmed. The car alerts 4 times light flashing and 4 times chirps.
These functions can be activated or de-activated by remote controller. All of these functions can be programmed when the key is located on “ACC” state in the key box. All of them are toggle functions and the default setting is “ON”. When these functions are activated, you can hear “BEEP_HI_LO”...
Page 6
removed by pressing any button of remote controller. 2-13. COMMUNICATION ERROR Sometimes you can see 3 times red LED flashing and dual beeps when you press any button of the remote controller. This means that the remote controller has communication error. The communication error can be happened following reasons.
This wire would be connected to the vehicle’s positive battery terminal or a constant positive +12V power supply. 2). BROWN : BROWN wire would be connected with the (+) wire of siren. And black wire of siren should be connected to ground. For corrosion resistance, the black wire of siren would be connected inside the vehicle under the dash board.
Page 8
The left switch is for DOOR LOCK when passive arming. If this DOOR LOCK switch is ON during passive arming is activated, the car door is locked. The car door will be UNLOCK state when the left switch is turned off ( located upward ) even though passive arming is activated.
Page 10
Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2)this device must accept any interference received, including interference that may cause undesired operation. DRAKE SYSTEMS ACE TECHNO 804, YANGPYUNG, YOUNGDEUNGPO , SEOUL 150-103, KOREA Tel : 82-2-2634-4700 Fax : 82-2-2634-4800...
Need help?
Do you have a question about the DTH-3002R and is the answer not in the manual?
Questions and answers