Table of Contents
Advertisement
Available languages
Available languages
Hz............................hertz
W.............................watts
min .........................minutes
or AC .............alternating current
or DC
....direct current
n o ...........................no load speed
...........................Class I Construction
(grounded)
...........................earthing terminal
..........................safety alert symbol
...........................Class II Construction
(double insulated)
.../min or rpm...revolutions or reciprocation
per minute
Wh ..........................Watt Hours
ASSEMBLY
WARNING:
repair the appliance
Wall Mounting
•
The product can be wall mounted, if desired, using the
wall mount bracket, screws and anchors supplied. To wall
mount the vac, refer to Figures B, C, D and E.
Figure B - Mark the location of the screw holes (within
•
reach of an electrical outlet for chargeing the vac while it
is on the wall bracket).
•
Figure C - Insert the charger cord into the curved slot in
the wall mount bracket
inches (203mm - 227mm) excess as shown.
Fig. B
8
•
Figure D - Hang the vac on the wall by placing the
opening on the base of the vac over the hooks in the
wall mount bracket as shown in Figure C.
Fig. D
Figure E - Insert the jack plug
•
socket.
Do not attempt to modify or
8
leaving approximately 8–9
Fig. C
8
10
nto the charging
Fig. E
Charging the battery
WARNING:
charger.
From new, the rechargeable cells of the product need a
minimum charge time of 16 hours to ensure full power.
•
The switch must be in the off ("O") position, the product
will not charge if it is in any other position.
•
Figure F - Plug the jack plug
charging socket
3
of the tool. Plug the charger into any
standard 120 Volt 60 Hz electrical outlet.
Fig. F
10
•
While charging, the charger may get warm, this
is perfectly normal and safe. It is safe to leave the
appliance connected to the charger indefinitely. The
charger automatically reduces power consumption
when charging is complete.
WARNING:
at ambient temperatures below 39°F (4°C) or above
104°F (40°C).
USE
Switching on and off (Fig. G)
Figure F - To start, slide the On/Off switch
•
(i.e. "O"= Off, "I" = On).
•
To stop, slide the switch back.
•
Return the product to the charger immediately after use
so that it will be ready and fully charged for the next
use. Ensure that the product is fully engaged with the
charger plug.
English
10
For use only with the supplied
10
of the charger into the
Do not charge the battery
1
forward
3
Hide quick links:
Advertisement
Table of Contents
