Venture Zebra G1-N User Manual page 13

OPERATING INSTRUCTIONS
1) Turn on the Skateboard and Sync the Remote Control
a) Press the power button on the left side of the skateboard as highlighted in Figure 1
b) Press the power button on the remote control as highlighted in Figure 2
c) The Bluetooth 4.0 remote control will sync with the skateboard automatically, generally after 3
seconds.
d) Press the check mark button on the remote control and listen for the skateboard to beep. A beep
means the remote and skateboard have paired properly.
e) Verify that the remote control has synced properly by turning the skateboard upside down, applying the
accelerator via the remote control and observing proper response of the skateboard (wheels turn) then
apply the brake and observe proper operation (wheels stop). If the skateboard does not respond properly,
turn the remote control off for 3 seconds, the repeat from step c) above.
2) Riding
To Start from a Stop:
a) Grasp the wireless controller firmly in your hand with your fingers wrapped around the front of it and you
thumb on the scroll wheel controller. Push the scroll wheel forward to accelerate, push the scroll wheel
backwards to brake or slow down
b) Hold the board still with gentle backward (braking) pressure on the scroll wheel until you are ready to
start moving.
c) Place one foot on the skateboard
© 2016 Shenzhen Venture Zebra Technologies Co., Ltd
PN V211292016M
www.vzg.com
Page 13