Clearing Errors; Maintenance - Olymp NC 450 Operating Manual

Clearing Errors

Errors are indicated in the display by an error code
and the display background turning red.
Error code Cause
Too little or no ultraviolet reaction from the
A
bank note.
Too little or no magnetic reaction from the
b
bank note.
Bank notes detected as being chained.
C
Bank notes as half bank notes.
F
Bank note count sensor
E01
Coding disk sensor
E03
Infeed tray sensor
E04
Output tray sensor
E05

Maintenance

Cleaning the Sensors
Bank notes are often soiled, particularly by dust. The
dirt deposits on the sensors during the counting
process. Soiled sensors are the most frequent cause
of malfunctions.
Clean the sensors with the brush supplied. Open the
bank note counter to clean the sensors. How to open
the bank note counter is described in the following
steps.
A frequent source of errors is soiling of the sen­
sors (see Cleaning the Sensors).
Solution
Remove critical notes from the batch.
Check the sensitivity setting of the UV sensor.
Remove critical notes from the batch.
Check the sensitivity setting of the MG sensor.
Check whether the bank notes stick together
and count the batch again.
Remove critical notes from the batch and
check for signs of damage.
Clean the sensor for counting the notes or
replace with a new one.
Clean the sensor for the coding disk or replace
with a new one.
Clean the sensor for the infeed tray or replace
with a new one.
Clean the sensor for the output tray or replace
with a new one.
Æ Grip the bank note infeed at the sides and remove
the infeed vertically out of the machine. Do not grip the
infeed in the middle section.
G
17