Subscribe to Our Youtube Channel
Related Manuals for Eureka Jewel Insert
Summary of Contents for Eureka Jewel Insert
- Page 1 Jewel Insert Jewel Insert Operation & Installation Instructions Rev * Please keep these instructions for future reference. 224438...
-
Page 2: Troubleshooting
Jewel Insert Jewel Insert Troubleshooting (Continued) Read and follow these instructions carefully before installing and WARNING using this appliance. To aid heater installation, remove door, ba e system and cast iron liners to reduce overall heater weight. • A ue re with resulting damage may occur if the appliance is not installed, WARNING operated and maintained as per this booklet. -
Page 3: Installation
It is your responsibility to arrange the same. Installation into existing or masonry replace The Eureka Jewel Insert can be installed into a masonry replace with a ue system that is in Total width accordance with the relevant sections of AS/NZS 2198:2001. - Page 4 An example of available thermal e ciency for a piece of wood as a fuel source at varying moisture levels. In some instances it may be desirable, or required that the Eureka Jewel Insert be installed into an existing replace which is raised above a combustible oor.
- Page 5 Squeeze locator tabs together on the rear of the thermostat switch and push through outside of pedestal. Fitting the steel ba e Disconnect the wiring from the power lead and remove the fans. Convey the same to the authorised Eureka dealer from whom you purchased your unit for service.
- Page 6 Jewel Insert Jewel Insert Basic Spare Parts Installation (continued) Flue and chimney requirements The ue pipe shall extend not less than 4.6m above the top of the oor protector. Note: Installation must be Figure 9 carried out by a licensed installer in accordance with AS/NZS 2918:2001.
- Page 7 Jewel Insert Jewel Insert Operating your Eureka Maintaining & Servicing your Eureka (continued) Figure 8 DO NOT ATTEMPT TO OPERATE THIS APPLIANCE WITHOUT READING AND WARNING UNDERSTANDING THESE OPERATING INSTRUCTIONS THOROUGHLY. FAILURE TO OPERATE THIS APPLIANCE PROPERLY MAY CAUSE UNDUE DAMAGE TO THE Read these instructions APPLIANCE OR RESULT IN A FLUE FIRE.
- Page 8 Firstly and carefully remove cast iron plates and ba e system and put to one side. Close the heater door. Obtain a 180mm Your Eureka Jewel is equipped with a temperature-sensitive thermostat switch located within the heater’s pedestal beneath ue brush from your local Jindara Dealer and proceed to the top of the ue. Remove the ue cowl. Slowly push the the rebox, which when selected will turn the fan on and o depending on the temperature of the rebox.
Need help?
Do you have a question about the Jewel Insert and is the answer not in the manual?
Questions and answers