Table of Contents
Advertisement
Advertisement
Table of Contents
Summary of Contents for Vetek WIFITD-1
- Page 1 WiFi to serial converter module WIFITD-1...
-
Page 2: Table Of Contents
Index Access to the configuration page ......................3 Ethernet ............................. 3 Wifi ..............................3 Ip address ............................4 IP address modification ........................... 7 Ethernet ............................. 7 TCP/UDP Port configuration ........................8 Serial port configuration ......................... 9 Security password ..........................10 Default and reset of the module ...................... -
Page 3: Access To The Configuration Page
Access to the configuration page The installation of the module must be performed by a qualified networks expert. Ethernet Connect the Ethernet cable to LAN port Wifi Connect PC to the HI-LINK Hotspot Security key is 12345678... -
Page 4: Ip Address
IP address The default IP address of the module is 192.168.16.254 Credentials are Username: admin Password: admin IN WIFI(CLIENT)-SERIAL CONFIGURATION MODE IT IS POSSIBLE TO ACCESS TO THE CONFIGURATION PAGE ONLY BY WIFI If the module is out of reach, it is necessary to configure the network card of the PC, at the IP address: 192.168.16.xxx, where xxx is an free IP, different from 254. - Page 5 To modify your IP address follow this procedure: Go on Networks connection center and click with the right button of your mouse on 2. Modify the network card configuration and choose Network card used by pc Choose the network card used by pc On the pop-up window choose: 3.
- Page 6 Type the IP address on the address bar of the browser http://192.168.16.254/ you can access the configuration page Default: Ethernet to serial WIFI(AP) to serial ETH-SERIAL Ethernet to serial WIFI disabled WIFI(CLIENT)-SERIAL Ethernet disabled WIFI(CLIENT) to serial WIFI(AP)-SERIAL Ethernet disabled WIFI(AP) to serial...
-
Page 7: Ip Address Modification
IP address modification Ethernet In the menu Serial2Net Settings is possible change the IP address, subnet mask and gateway of Ethernet... -
Page 8: Tcp/Udp Port Configuration
TCP/UDP Port configuration For each port it is possible to change the communication parameters for both TCP and UDP ports... -
Page 9: Serial Port Configuration
Serial port configuration For each port, you can change the parameters of serial communication... -
Page 10: Security Password
Security password Is possible to protect the configuration of the module. -
Page 11: Default And Reset Of The Module
Default and reset of the module You can make the default of the module: Press one of these two buttons for 8 seconds. If reset is done, green LEDS should be OFF for 3 seconds... -
Page 12: Technical Specifications And Connection
Technical specifications and connection Supply voltage + 5 Vdc Max power usage 250 mA Operating temperature -20°C + 85°C Protocols TCP, UDP, DHCP, HTTP, ICMP, uPnP, ARP, Telnet WEB interface 10/100 Base-T. Communication Rate 10/100Mbps.
Need help?
Do you have a question about the WIFITD-1 and is the answer not in the manual?
Questions and answers