Page 1
External Aquarium Filter/Pump - P6000 User Manual [Revision 3.0 August 2018] READ THIS MANUAL CAREFULLY BEFORE USE – FAILURE TO DO SO MAY RESULT IN INJURY, PROPERTY DAMAGE AND MAY VOID WARRANTY. • KEEP THIS MANUAL FOR FUTURE REFERENCE. • Products covered by this manual may vary in appearance, assembly, inclusions, specifications, description and packaging.
External Aquarium Filter/Pump - P6000 Safety Safety messages are designed to alert you to possible dangers or hazards that could cause death, injury or equipment or property damage if not understood or followed. Safety messages have the following symbols: You WILL be KILLED or...
Page 3
External Aquarium Filter/Pump - P6000 General Electrical Safety General Electrical Safety General Service Information • Inspect electrical equipment, extension • Electrically grounded equipment must • The equipment must be serviced or cords, power bars, and electrical fittings have an approved cord and plug and repaired at authorised service centres for damage or wear before each use.
External Aquarium Filter/Pump - P6000 Safety Symbols The product may have safety warning labels attached to it, explained below. Understand the symbols on your product and their meanings. If any stickers become unreadable, unattached etc, replace them. Flammable Material Hazard...
Page 5
External Aquarium Filter/Pump - P6000 Carbon-Monoxide Hazard Pull Hazard Slope / Fall Injury Hazard "Slam Dunk" Warning Do not use the product in Be aware that the product Be aware that using the Do NOT attempt "slam dunk" confined areas or without...
External Aquarium Filter/Pump - P6000 Assembling the Water Intake/Drainage Tubes Operation Guide 1. Figures 1 and 2: The buckles should be unfastened first, which will separate the main body and the barrelhead. 2. Figures 1 and 2: Put the draining skeps with the filter medium into the main body. Press the barrelhead with your hands to combine the main body and the barrelhead.
External Aquarium Filter/Pump - P6000 NOTE: The curvy tube with the spray tube is the drainage tube; the curvy bar with the dirt/waste entrance tube is the intake tube. 5. Figure 5: Press the big blue button. It will then rebound. The intake tube will then pump water into the main body, which pushes the air out of the main body through the drainage tube.
External Aquarium Filter/Pump - P6000 Filter Management Problem Cause Solution Re-connect the intake and Filter does not respond when the The intake and drainage tubes drainage tubes again; the tube with big blue button has been pressed. have not been connected correctly.
External Aquarium Filter/Pump - P6000 Specifications Flow Rate 2,400 Litres per hour Tank Capacity Suitable for tanks of up to 480L Frequency 50Hz Input 240v AC Power 1.4m (for optimum output this unit Head-Max Output should sit beside or below the tank) ...
Page 12
External Aquarium Filter/Pump - P6000 Some experts believe that the incorrect or prolonged use of almost any product may cause serious injury or death. To help reduce your risk of serious injury or death, refer to the information below. For more information, see www.datastreamserver.com/safety...
Need help?
Do you have a question about the P6000 and is the answer not in the manual?
Questions and answers