Summary of Contents for Techni-Lux DL-G2R
- Page 1 Information specifically for: DL-G2R V1.0 This manual contains important information. Please read before operating fixture.
- Page 2 It is the owner’s responsibility to provide invoices for proof of purchase, purchase date and dealer or distributor. If purchase date can not be provided, warranty period will start at manufacture date. It is the sole discretion of Techni-Lux to repair or replace parts or equipment.
-
Page 3: Table Of Contents
Table of Contents Specifications ..........................4 Fixture Overview ........................4 Unpacking ........................... 6 Purpose of Manual ........................6 Power ............................6 Basic Reference .......................... 7 Mounting ............................. 7 Setup ............................8 Gobo Holder ..........................8 ... -
Page 4: Specifications
Specifications Fixture Overview Light Source: 30 W White LED Beam Angle: 17 degrees Stand-alone / IR remote Manual adjustment focus Smooth dimming (16-bit, 4 dimming curves for options) Variable Speed Gobo rotation in both directions ... - Page 5 Environmental Environmental Rating IP44 Max. ambient temperature 105°F (40°C) Min. distance to flammable surface 1.0ft (0.3m) Electrical Power Requirements Auto Ranging 100 – 240Vac, 50-60Hz @35 Watts Power Input Fuses Internal Rating Approval Control On Board Buttons for Gobo Control Wireless IR Remote Optics...
-
Page 6: Unpacking
Unpacking Immediately upon receipt, carefully unpack and inspect the fixture to verify that all parts are present and have been received in good condition. If any parts appear damaged from shipping or the shipping carton shows signs of mishandling, notify the shipper immediately. Retain carton and all packing material for inspection. -
Page 7: Basic Reference
Basic Reference 1 IEC Power Inlet 2 Mounting Bracket 3 IR Sensor and Control Buttons 4 Coarse Focus Lens Assembly 5 Fine Focus Bezel 6 Gobo Holder 7 IR Remote Mounting The supplied bracket allows for placement on a flat surface such as a table or for hanging with optional clamp (not supplied). -
Page 8: Setup
Setup Gobo Holder The Gobo Holder uses Standard “E” size Gobos (1.5” / 37.5mm), Metal or Glass. The fixture produces no significant heat or UV allowing self-printed custom designs on transparent printer film. Two gobo holders are supplied with the projector. Remove Gobo Holder The gobo holder is held in place by magnets. -
Page 9: Operation
Operation Functions are set using the Buttons on the front of the projector or with the IR Remote. Only the IR Remote allows for control of the Dimmer and BlackOut function. Settings are automatically retained and the projector returns to the same state whenever power is connected. -
Page 10: Maintenance
Order Code Description CT-G2R/RM IR Remote Control for DL-G2R LED Gobo Projector GH-G2R/E Gobo Holder for DL-G2R, holds size E Glass Or Metal ZEPO0001 Power Cord - 18AWG SJT x 6' Molded Edison to IEC CL-CBHALF Half Cheese-borough Coupler 2” Pipe CL-MEGA/B Mega 2”... -
Page 11: Troubleshooting
Troubleshooting Symptom Possible Cause / Solution No Power Check for power on mains Check if fixture is in BlackOut Erratic Rotation Check proper fit of Gobo Holder Check for debris interfering with Gobo Holder Clean Gobo Holder and Fixture Cannot Focus Clean Fixture Surface too close or not flat... - Page 12 10900 Palmbay Drive • Orlando, FL 32824 U.S.A. www.techni-lux.com...