Summary of Contents for Ranger Electronic VX-129CN
Page 1
ςΙΡΑΓΕ ςΙΡΑΓΕ ςΙΡΑΓΕ ςΙΡΑΓΕ VX-129CN S/RF AN L TONE C H9 TX/RX ς ΙΡ ΑΓ Ε ς Ξ −12 9 ΧΝ C AL N OR MAL AN T MIC GAIN RF GAIN SWR CAL CLARIFY SOLID STATE 40 CHANNEL AM MOBILE CB RADIO OWNER’S MANUAL...
LOCATION Plan the location of the transceiver and microphone bracket before starting Model VX-129CN the installation. Select a location that is convenient for operation and does not Channels interfere with the driver or passengers in the automobiles, the transceiver is Frequency Range 26.965 ~ 27.405 MHz...
IGNITION NOISE INTERFERENCE TUNING THE ANTENNA FOR OPTIMUM S.W.R Use of a mobile receiver at low signal levels is normally limited by the Since there is such a wide variety of base and mobile antennas, this section presence of electrical noise. The primary source of noise in automobile will strictly concern itself to the various types of mobile adjustable antennas.
If you’re having difficulties in adjusting your antenna, check the following: CHAPTER 3 OPERATION All doors must be closed when adjusting the antenna Make sure the antenna base is grounded. FRONT PANEL Check your coaxial cable routing (it may be pinched when routed into 10 11 13 14 the car)
6. SWR CAL CONTROL : This SWR CAL control allows the user to 18. CHANNEL DISPLAY : The channel display indicates the current calibrate the SWR meter. selected channel. 7. CLARIFY CONTROL : Allows tuning of the receive frequency above 19.
FREQUENCY CHART PROCEDURE TO RECEIVE AND TRANSMIT Channel Channel Frequency Channel Channel Frequency A. MICROPHONE The receiver and transmitter are controlled by the push-to-talk switch on 26.965 MHz 27.215 MHz the microphone. Press the switch and the transmitter is activated, release switch to receive.
Before beginning the actual wiring, read carefully the circuit and wiring ALTERNATE MICROPHONES AND INSTALLATION information provided with the microphone you select. Use the minimum heat required in soldering the connections. Keep the exposed wire lengths to a For best results, the user should select a low-impedance dynamic type minimum to avoid shorting when the microphone plug is reassembled.
5. The wires must now be soldered to the pins as indicated in the above 9. The two cable clamp retainer screws should now be tightened to secure wiring tables. If a vise or clamping tool is available it should be used to the housing to the microphone cord.
A FEW RULES THAT SHOULD BE OBEYED USE CH 9 FOR EMERGENCY MESSAGES ONLY 1. You are not allowed to carry on a conversation with another station for The FCC gives the following examples of permitted and prohibited types of more than five minutes at a time without taking a one-minute break, to communications for use in an emergency.