Advertisement
Operating
Instructions
! C UTION !
1. Mueller Canada has made every effort to ensure that this manual is accurate and correct, and cannot be held liable for its misuse. Part numbers shown are
current at time of printing and may be subject to change due to changes in design or material.
2. Standard safety practices should be observed when working with the equipment described herein, or any other associated tools.
3. Mueller Canada will assume no responsibility or liability for any malfunction or damage caused by, or resulting from, the use of parts not manufactured by
Mueller Canada. Use of such parts will void any and all warranties as well as third party approvals and endorsements.
Copyright © 2014 Mueller Co., LLC. All Rights Reserved. The trademarks, logos and service marks displayed in this document are the property of
Mueller Co., LLC, its affiliates or other third parties. These products are intended for use in potable water applications. Please contact your Mueller Sales or
Form MC005-rev04/15
CENTURY FIRE HYDR NT
B-50-B18 HYDR NT
B-50-B24 HYDR NT
Barrie, ON, L4N 8Z9
www.muellercanada.com
Customer Service Representative concerning any other application(s).
Printed in U.S.A.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Mueller B-50-B18
- Page 1 ! C UTION ! 1. Mueller Canada has made every effort to ensure that this manual is accurate and correct, and cannot be held liable for its misuse. Part numbers shown are current at time of printing and may be subject to change due to changes in design or material.
- Page 2 INDEX CENTURY FIRE HYDR NT, B-50-B18 HYDR NT, B-50-B24 HYDR NT Page Installation, Operation, Inspection and Maintenance ..........3-4 Internal Parts Removal and Hydrant Valve Rubber Replacement.....5 Hydrostatic Test, 100mm Storz dapter and Storz Nozzle Installation ........6 Notes..............7 www.muellercanada.com...
- Page 3 CENTURY, B-50-B18 ND B-50-B24 FIRE HYDR NTS Installation, Operation, Inspection and Maintenance INST LL TION Nozzle caps should be sufficiently tight to prevent removal by hand. NOTE: The following information is supplemental to the WW M-17 manual. OPER TION When hydrants are received, they should be handled...
- Page 4 CENTURY, B-50-B18 ND B-50-B24 FIRE HYDR NTS Installation, Operation, Inspection and Maintenance Non-Draining Hydrants – Non-draining (plugged) joint of existing nozzle and re-pouring and caulking hydrants should be clearly identified. Unauthorized joint for new nozzle. Resilient sealed nozzle may be use of non-draining hydrants can result in damage or replaced using kit available from Mueller Canada.
- Page 5 CENTURY, B-50-B18 ND B-50-B24 FIRE HYDR NTS Internal Parts Removal and Hydrant Valve Rubber Replacement HYDR NT V LVE RUBBER REPL CEMENT • Slide plastic sleeve (P/N 294403) over rod end and Figure 1 (illustrated below) is current production use sleeve to position O-ring in recess in valve top.
- Page 6 CENTURY, B-50-B18 ND B-50-B24 FIRE HYDR NTS Hydrostatic Test, Storz dapter and Storz Nozzle Installation HYDROST TIC TEST • "Snug'' into position (using bar as illustrated in • Remove a cap and open hydrant so barrel fills with Figure 3), but do not over tighten.
- Page 7 CENTURY, B-50-B18 ND B-50-B24 FIRE HYDR NTS Notes...
Need help?
Do you have a question about the B-50-B18 and is the answer not in the manual?
Questions and answers