Electric Eel RF Operator's Manual

Electric Eel RF Operator's Manual

Drain cleaning machine

Advertisement

Quick Links

MODEL RF
Drain Cleaning Machine
Operator's Manual
ELECTRIC EEL MANUFACTURING CO., INC.
501 West Leffel Lane, Springfield, Ohio 45501-9885
Call Toll Free (800) 833-1212 (937) 323-4644
www.electriceel.com
!! DANGER !!
FOR YOUR SAFETY
Before you operate or
maintenance this equipment,
READ this manual carefully and
completely!
The Electric Eel Model RF Drain
Cleaning machine is a professional
quality sewer and drain cleaning piece of
equipment. This machine is specifically
designed for cleaning 3" to 6" drain lines
up to 100 feet in length and features a
two-way auto cable feed for ease of
operation. A cable guide spring also
keeps hands off rotating cable near the
machine.
FAX: (937) 323-3767
Proudly Made in The USA Since 1939

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RF and is the answer not in the manual?

Questions and answers

Summary of Contents for Electric Eel RF

  • Page 1 Before you operate or maintenance this equipment, READ this manual carefully and completely! The Electric Eel Model RF Drain Cleaning machine is a professional quality sewer and drain cleaning piece of equipment. This machine is specifically designed for cleaning 3” to 6” drain lines...
  • Page 2 STANDARD EQUIPMENT DANGER Electric Eel Model RF comes complete with: • RF unit with auto cable feeder • Cable guide spring To prevent serious injuries including: • Shock, electrocution or burns due • 100 ft. of 3/4” Tri-Max Cable to improper grounding.
  • Page 3 11. To maintain safe operation, use only identical replacement parts 6. If an extension cord is used, the power source MUST be equipped and cables from Electric Eel. with a Ground Fault Circuit 12. ALWAYS keep clear of rotating Interrupter (GFCI) and properly cages/drums, shafts, pulleys, grounded.
  • Page 4 7. Only use 10/3 or larger three-wire GENERAL SAFETY– extension cords with three-prong ROTATING CABLES grounding plugs and three-pole AND EQUIPMENT receptacles. 8. When using an extension cord DANGER outdoors, only use those intended for outdoor use. (Indicated on cord by suffix “W-A”...
  • Page 5 7. NEVER force a tool and cable into MACHINE SET-UP a pipeline blockage. This may overload the cable or tool and cause it to fracture. DANGER 8. ALWAYS wear HEAVY leather gloves and safety glasses when TO PREVENT SERIOUS BODILY operating machine.
  • Page 6 This tool will enable you to bore a starter Standard Tools Included with the hole in the obstruction, allowing Model RF Kit: backed-up water to drain. 1. SC-18 Spanner Wrench NOTE: The flexible leader should 2.
  • Page 7 6. WITH POWER ON, in order to Figure 3 feed cable, the operator must move the feeder control lever from NEUTRAL (the position midway between FORWARD and REVERSE) to the FORWARD position, while depressing the foot actuator. (See Figure #2 for FORWARD feeder position) Figure 2 7.
  • Page 8 8. If tool becomes hung up in the 11. When tool is close to cleanout obstruction, move control lever to opening, return Control Lever to the REVERSE position to back NEUTRAL position, place switch out tool. (See Figure #5) in OFF position, release foot actuator and allow machine to Figure 5 come to a complete stop.

Table of Contents