Summary of Contents for XL Joinery EASI-GLIDE
- Page 1 XL JOINERY LTD EASI-GLIDE INSTRUCTIONS PLEASE READ AND UNDERSTAND THESE INSTRUCTIONS FULLY PRIOR TO STARTING INSTALLATION. IT IS STRONGLY RECOMMENDED THAT A COMPETENT TRADES PERSON INSTALLS THIS PRODUCT.
- Page 2 Single and Double Width Pelmets are supplied over-sized for on-site trimming to suit aperture and door width/s. Ensure that the wall that the Easi-Glide system is fitted to is not obstructed by skirting boards, light fittings, etc. Doors cannot be reduced in height from the top door edge lipping: The full lipping thickness is required for secure fixing of the Adjuster Bolts to the door.
- Page 3 Fit the Hangers to Top Edge of the Door Mark the Hangers location centrally, 430mm apart from the centre of the door’s top edge. Pre-drill the Hanger bolts. Drill 10mm holes into the top door edge 38mm deep and place the Hanger bolts into the holes. Mark the position of the screw fixing holes and pre-drill, prior to permanently fixing the Hanger Bolts screws.
- Page 4 Fit the Pelmet to the Wall Determine the track height required ensuring there is approximately 5mm between the floor and the bottom edge of the door and that the door covers the height of the aperture. Ensure that the Pelmet is level and pre-drill through the track holes and Pelmet into the wall. Secure the Track and Pelmet to the wall using suitable fixings.
- Page 5 Fit the Fascia to the Pelmet After fitting the Pelmet to the wall and making any hardware adjustments, fit the Fascia to the Pelmet: Ensure that the Fascia is pre-drilled prior to screwing through the pre-drilled Pelmet. Pelmet: Fascia Delivered Unassembled for Assembled Pelmet Pre-drilled Pelmet Pre-drilled Screw...