Advertisement
5. MAINTENANCE
WARNING! Disconnect wrench from air supply before changing accessories, servicing or
performing maintenance.Replace or repair damaged parts. Use genuine parts only.
Un-authorised parts may be dangerous and will invalidate the warranty.
5.1.
If the air system does not have an oiler, lubricate the air wrench daily with a few drops of
Sealey air tool oil dripped into the air inlet to prolong its life.
5.2.
Clean the wrench after use. DO NOT use worn or damaged sockets.
5.3.
Loss of power or erratic action may be due to the following:
a) Excessive drain on the air line. Moisture or restriction in the air pipe. Incorrect size or
type of hose connectors. To remedy check the air supply and follow instructions in
section 3.
b) Grit or gum deposits in the wrench may also reduce performance. If your model has
an air strainer (located in the area of the air inlet), remove the strainer and clean it.
Flush the wrench out with gum solvent oil or an equal mixture of SAE No 10 oil and
paraffin.
Allow to dry before use.
5.4.
For a full service contact your local Sealey service agent.
5.5.
When not in use, disconnect from air supply, clean wrench and store in a safe, dry,
childproof location.
Twist to change direction
© Jack Sealey Limited 2013
fig 3
Original Language Version
SA632, SA633 Issue: 3 (SP) - 29/08/13
Advertisement
