Advertisement
4.3
referring to fig.2 take two M6 x 35mm bolts (2) and drop two
Ø6mm washers (12) onto them. Align one leg (14) with the
holes in the hopper and insert the bolts through the hopper and
the leg. screw a wing nut (10) onto each bolt and tighten them
up to draw the leg firmly up against the hopper. Attach the
other leg to the hopper in the same way. see fig.3.
fig.2
fig.3
fig.1
4.4
referring to fig.4, assemble a connecting tube (19) to each leg
using an M6 x 35mm hex headed bolt (2) and an M6 Wing nut (10).
firmly tighten each nut as shown in fig.5.
4.5
referring to fig.6, push the handle onto the connecting tubes
and fix in place using an M6 x 30mm bolt (1) and an M6 Wing
nut (10) at each connection. firmly tighten each wing nut.
fig.6
Original Language Version
fig.4
fig.5
sPD27W
Issue: 1 - 13/06/11
Advertisement
