Swivelpole F19 Installation & Operation Manual

I N S T A L L A T I O N & O P E R A T I O N G U I D E
NOTE: This guide should be followed in conjunction with your own worksite
Procedures, Safety Rules and Regulations to ensure the F19 Swivelpole™ is
assembled and installed safely, and correctly to optimise it's performance.
Before installation please ensure you have read the Operation and Safety
Information.
This guide should be followed to ensure the Swivelpole™ is assembled and
installed safely and correctly.
Copies of general assembly drawings are available at
www.swivelpole.com
Installation of Swivelpole™ F19
1. Feed the electrical cable
through the base section of the
Swivelpole™ to the access panel.
2. Position the base section over
the installed cage bolts.
3. Rotate the Swivelpole™
base section to the desired
orientation.
4. Align the base section so it is
vertical.
5. Tighten base plate bolts.
6. Slide the base cowling over the
base pole to cover the base plate.
7. Feed the electrical cable through
the pole top prior to bolting to
the swivel plate.
8. Apply multi-purpose grease to
swivel plate surfaces and bolts.
9. Slide the clamp plate onto the
pole top.
10. With one person holding the
pole top horizontally, the second
person can position the round
swivel plate locator into the hole
of the base section swivel plate.
11. Bolt the clamp plate to the swivel
plate, using the fastening kits.
Refer to Figure 1: For lowering
direction preference.
12. Tighten the bolts evenly.
Figure 1
AS SHOWN FOR
R/Hand LOWERING
AS SHOWN FOR
R/Hand LOWERING
DEPENDING ON SITE
DEPENDING ON SITE
CONDITIONS CLAMP
CONDITIONS CLAMP
PLATE AND STOP TAB
PLATE AND STOP TAB
SAFETY PIN CAN BE
PLUNGER CAN BE
INSTALLED ON THE OP-
INSTALLED ON THE
POSITE SIDE TO ALLOW OPPOSITE SIDE TO
ALLOW FOR L/Hand
FOR L/Hand LOWERING
LOWERING
SP-IEC-Installation Guide F19-20180830
13. Apply enough tension to allow
controlled raising of the pole top,
at this point the Swivelpole™ will
be self supporting.
14. To raise, use two people to guide
it as it swivels to the upright
position.
15. Insert the safety pin.
16. With the pole top in the upright
position, mark the pole in the
direction the fixture is to face,
and lower it again to fit the
fixture.
17. Slide the joint cowling onto the
pole top using a spring clamp to
keep the joint accessible.
18. To lower, retract the safety pin
and swivel the pole top down to
a safe working height and insert
the safety pin.
19. Fit the fixture mount as per
marked position on pole top.
20. Tighten the grub screws to a
torque setting of 17Nm to 20Nm.
21. Complete installation and
termination of the fixture.
22. Raise the Swivelpole™ and insert
F19 Installation Guide - Views
the safety pin. Tighten the
bolts evenly to a torque setting
between 40Nm and 80Nm.
23. Lower the cowling over the joint
and tighten the tamper proof
screw.
Luminaire
Mount
Pole Top
F19 Installation Guide - Views
Pole Top
Joint
Cowling
Base
Spring
Clamp
(not
Joint
supplied)
Cowling
Joint
INSTALLATION
Access
Panel
Base
Luminaire
Mount
Access
Panel
Base
Cowling