Dance Move Technology Dmove Manual

Manual of Dmove Intelligent Dance Pedometer
The product is an intelligent terminal, it uses acceleration sensors to track and calculate dance
steps, then transfers the results to the related APP on the mobile phone through Bluetooth, thus
realizes the objective of managing the dance data.

Product Structure

1. The product contains three parts, the main device / charging part / wearing accessory.
2. Can be supported by IOS / Android system.
3. The main device is supposed to be installed in the sole.
4. Bluetooth launch within the distance of 5-10 meters.

Accessories

1. The Dmove main device * 1
2. Charging base * 1
3. USB cable * 1
4. Wearing accessory * 2

Main Device Hardware Functions

1. The working voltage is 3.3V.
2. The main console adopts low-power-consumption Bluetooth 4.0 chip.
3. Acceleration sensor.
4. 3.7 V polymer lithium battery, with capacity of 20~25 mA and protective board.
5. Using magnet material to fix two parts when charging.
6. LED – bicolor indicator light, red / blue.
7. Users can check the electric quantity of main device through the APP.
8. The product can work continuously for up to ten hours and standby for up to two weeks
when full charged.
9. The product is turned off when left the factory, and it can be activated when first charged,
which only takes 5 seconds.
10. Users can retrieve the main device through the APP, which makes the blue indicator light
on for 6 seconds.

Charging Base Functions

1. The working voltage is 5V (USB).
2. The charging current is 20 mA.
3. Working state
(1) Standby. When connected to the power supply, the blue indicator light will be on for a
long time after the red one flashes twice.
(2) Charging. When putting the main device onto the charging base, the flashing red light