Advertisement
Caution
Failure to follow these instructions can damage the product or cause a hazardous
condition. Disconnect power during the installation of this product. All wiring must
conform to local codes and ordinances. This product is designed for use with 24
VAC systems.
For additional assistance visit www.PelicanWireless.com to request support.
Introduction
The plus50 provides a hardware upgrade to add CO
Pelican thermostats including the TS200 and TS200H. Once installed, the
thermostat will provide continuous status of CO
ventilation in three ways:
1.
Control of the Pelican Pearl Economizer Controller.
2.
In coordination with Pelican's line of Zone Controllers with integrated
Economizer Control.
3.
Simple fan operation when CO
Prerequisites
Existing Pelican thermostats will not recognize the CO
running at least firmware version 3.0. We recommend verifying the firmware version
before beginning installation. Contact Pelican Technical Support at
support@PelicanWireless.com or 888-512-0490 for assistance verify the firmware
version and if necessary to receive the free firmware upgrade.
Installation
The plus50 is provided as a replacement sub-base. The existing thermostat front
plate and internal Wiring Module (WM500 or WM700) will need to be installed into
the new sub-base. For installations where the Wiring Module has already been
relocated to a different location the new sub-base can replace the existing sub-base
without removing and re-installing the Wiring Module.
The installation steps are:
1.
Turn off power to the thermostat.
2.
Remove the existing front plate by pulling it straight away from the base.
3.
Disconnect all control wiring.
4.
Remove the existing Wiring Module as shown in the following section.
5.
Remove the existing sub-base and install the new sub-base.
6.
Re-install the Wiring Module into the new sub-base.
7.
Reconnect control wiring. Re-install the thermostat front plate.
Installation Guide
PLUS50 integrated CO
sensor capability to existing
2
levels and can provide demand
2
levels exceed the CO
2
sensor unless they are
2
1
Sensor
2
set point.
2
Advertisement
Table of Contents
Related Manuals for Pelican PLUS50
Summary of Contents for Pelican PLUS50
- Page 1 Installation The plus50 is provided as a replacement sub-base. The existing thermostat front plate and internal Wiring Module (WM500 or WM700) will need to be installed into the new sub-base. For installations where the Wiring Module has already been relocated to a different location the new sub-base can replace the existing sub-base without removing and re-installing the Wiring Module.
- Page 2 Wiring Module Removal and Installation The following diagram shows how to remove the Wiring Module and then re-install the Wiring Module into the new plus50 sub-base. Step 1: Pull front plate off Step 2: Loosen R and Rc terminals and remove jumper. Loosen R, C, D TS200 or TS200H.
Need help?
Do you have a question about the PLUS50 and is the answer not in the manual?
Questions and answers