Advertisement
3.2
Quality point
When you assemble the unit, please check the following points for keeping the quality.
[1] TOP COVER ASSY
Fig.3-1-1
OK
When attaching the TOP COVER, properly
set the rear side.
[2] WINDOW (WB)
Fig.3-1-2
To attach the WINDOW (WB), slide it under the FRONT COVER.
Be careful not to set the WINDOW (WB) over the FRONT COVER.
[4] FRONT ASSY
Fig.3-1-4
OK
Run the MIC FPC inside the FRONT COVER.
[6] MAIN BOARD ASSY
Fig.3-1-6
OK
Between the JACK and the MAIN, do not catch the
FFC with the BOTTOM.
1-12 (No.YF365<Rev.001>)
NG
NG
NG
[9] OP BLOCK ASSY
Fig.3-1-9
OK
NG
Between the CMOS and the MAIN, run the FPC
under the mold.
[10] SHUTTER ASSY
Fig.3-1-10
To replace the BARRIER UNIT, open the BARRIER to check the screws.
(The screws cannot be observed with the BARRIER closed.)
[12] REAR BOARD ASSY
Fig.3-1-11
OK
NG
Be careful not to insert the FPC in reverse direction
paying attention to the PET affixed position.
[18] CMOS FRM ASSY
Fig.3-1-17
Do not apply excessive shock to the CMOS ASSY.
Hide quick links:
Advertisement
