Subscribe to Our Youtube Channel
Related Manuals for CENS PROFLEX
Summary of Contents for CENS PROFLEX
- Page 1 CENS ® ProFlex User Guide Contains important information - do not throw away Version 1.07 EN352 May 2016...
- Page 2 2002/96/EC of the European Parliament and of the Council of 27 January 2003 on waste electrical and electronic equipment.” Amended by “Directive 2003/108/ EC” (WEEE). Recycle CENS® ProFlex, batteries and accessories according to national regulations. With the CE marking Puretone Ltd confirms compliance with the European...
-
Page 3: Table Of Contents
Intended Use General Notes On Safety Handling Batteries Inserting The Battery Removing The Battery Modules Cleaning Inserting & Removing The CENS® ProFlex 12-13 Turning Your CENS® ProFlex On & Off + Adjusting The Volume 14-15 Programs Troubleshooting Technical Information 18-19... -
Page 4: Your Cens® Proflex
Clear tip Blue dot = left ear / Red dot = right ear Every CENS® ProFlex can be identified by the serial number located on the underside of the module. The intended users name (personal ID) will be laser marked onto each silicone earpiece. -
Page 5: Intended Use
CENS® ProFlex are not intended or suitable for use as a hearing aid or to provide any correction for hearing loss. Read and follow the instructions of this user guide to avoid injuries or damage to the CENS®... -
Page 6: General Notes On Safety
Do not wear them in the shower or when you apply make-up, perfume, aftershave, hairspray or suntan lotion. Do not wear your CENS® ProFlex when you are exposed to short- waves, a strong magnetic field, a high frequency field or X-rays. - Page 7 Dispose batteries according to national regulations or return them to your supplier. Hazard of explosion! Do not use your CENS® ProFlex in areas where there is a danger of explosions (e.g. mining). NOTICE These are reusable devices, and it is strongly recommended that they are regularly inspected to ensure correct fit and functionality.
-
Page 8: Handling Batteries
Battery life may vary depending on ambient sound levels and environmental conditions such as humidity. Always use the correct size of batteries, as supplied with your CENS® model. Remove the tab on your batteries only when you are ready to use them. -
Page 9: Inserting The Battery
Inserting The Battery Open the battery tray. Place the new battery on the magnet stick as shown. Insert the battery into the tray bottom first, as shown in the diagram, and then tilt the stick up to insert the top of the battery. Finally, remove the battery stick from the new battery, and close the battery tray. -
Page 10: Modules
Modules CENS® ProFlex digital custom electronic noise suppressors are designed with a removable modular format for ease of use, easier cleaning and maintenance. The module is designed to snap fit into the preformed silicone earpiece. Left Ear Right Ear CENS® ProFlex... -
Page 11: Cleaning
Cleaning and Disinfection It is recommended that you clean your CENS® ProFlex digital after every use to keep them in perfect working condition. Remove the module from the earpiece before cleaning. Use the brush to clean the sound hole. Your CENS® ProFlex is a highly sensitive system. Proper care and handling will ensure the best possible performance. -
Page 12: Inserting & Removing The Cens® Proflex
Inserting & Removing The CENS® ProFlex Inserting The Left Ear Right Ear Earpiece Hold the earpiece around the electronic module. Place the clear ear tip into the ear canal and slightly rotate the earpiece backwards while inserting into the ear canal. - Page 13 Never pull on the battery compartment door or volume control wheel to remove the CENS® ProFlex, as this could cause damage. Sudden or fast removal of ear-plugs from the ear canal may damage the ear drum.
-
Page 14: Turning Your Cens® Proflex On & Off + Adjusting The Volume
Turning Your CENS® ProFlex On & Off Left Ear Right Ear Turn the device on/off using the rotary volume/power control switch. Gently rotate the control in the directions shown to turn on/off. Adjust the volume to a comfortable level using your fingertip to gently rotate the control. - Page 15 Adjusting The Volume DO NOT use your CENS® ProFlex earpieces without either the electronic or passive module being fitted. Once the devices are switched on, you will be able to hear sound as normal; however, when a loud sound is detected the device will automatically reduce the volume to a safe and comfortable level.
-
Page 16: Programs
Programs Device models fitted with a program switch (shown above) have multiple programs. These have been optimised for the intended use by the user. Details of these programs can be found in the Additional Information booklet supplied. Program 1 is automatically selected by default when turning devices on. When the program button is pressed, 2 beeps will be heard indicating Program 2 and 1 beep for Program 1 as the button is repeatedly pressed. -
Page 17: Troubleshooting
CENS® ProFlex emits signal tones. Gently close battery compartment completely. Replace empty battery. CENS® ProFlex does not work. Check if the CENS® ProFlex is turned on. Gently close battery compartment completely. Replace empty battery. Make sure battery is inserted correctly. -
Page 18: Technical Information
Technical Information (EN352) Electronic Module - Sound Attenuation Frequency (Hz) 1000 2000 4000 8000 Mean Attenuation 26.1 24.6 23.2 23.3 23.4 31.6 31.8 36.4 Standard Deviation Assumed Protection 19.7 20.0 19.4 19.8 20.0 28.0 28.5 31.6 H=27 M=21 L=20 SNR=25 Passive Module - Sound Attenuation Frequency (Hz) 1000... - Page 19 Technical Information (EN352) SNR = Single Number Rating attenuation High frequency attenuation Medium frequency attenuation Low frequency attenuation EN352-2:2002 EN352-7:2002 Tested by: INSPEC Certification Services, 56 Leslie Hough Way, Salford, Greater Manchester, M6 6AJ. UK. Further information can be obtained from Puretone Ltd, 9-10 Henley Business Park, Trident Close, Medway City Estate, Rochester, Kent.
- Page 20 ISO 9001:2008 ISO 13485:2003 MDD 93/42/EEC CENS® is a registered trademark of Puretone Ltd CENS® module is protected by EC Design Registration No. 001861998-0001 Norwegian Design Registration No. 083344 South African Design Registration No. 2011/01813 US Design Patent Pending EN352-2:2002 & EN352-7:2002, by Inspec International...
Need help?
Do you have a question about the PROFLEX and is the answer not in the manual?
Questions and answers