Table of Contents 1. INTRODUCTION ................5 Specification ........................6 Package ..........................7 Installation .......................... 8 2. OPERATING YOUR KDCSLED-HF ..........9 Configuration ........................9 Configuration barcodes ....................9 How to read NFC Tags ....................10 3. WARRANTY ..................11 4.
Page 3
No part of this publication may be reproduced or used in any form, or by any electrical or mechanical means, without permission in writing from KOAMTAC, Inc. The material in this manual is subject to change without notice. KOAMTAC reserves the right to make changes to any product to improve reliability, function, or design.
Page 4
KDCSLED-HF User Manual NTRODUCTION This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
NFC. When it is connected to KDC Sled model(as like KDC470), it enables user to collect data with NFC Tag. To find out more about KOAMTAC, Inc. and our family of products, visit us at www.KOAMTAC.com. Revision 1.1...
KDCSLED-HF User Manual ARRANTY 1.2 Package The standard KDCSLED-HF package contains: 1. One KDCSLED-HF 2. 4 screws + 1 extra Revision 1.1 Copyright®2012-2018, KOAMTAC, Inc.
KDCSLED-HF User Manual ARRANTY 1.3 Installation Align KDCSLED-HF screw holes to screw holes on KDC SLED.(As like KDC470) • Use 4 screws to fasten KDCSLED-HF to KDC SLED. • Revision 1.1 Copyright®2012-2018, KOAMTAC, Inc.
KDCSLED-HF User Manual ARRANTY 2. Operating your KDCSLED-HF 2.1 Configuration NFC Power Turning NFC Power on or off Options: Enable/Disable Data Format Options: Data only/Packet data. UID Only Enable or Disable UID Only menu The KDC only sends UID data to the host device when the KDC is in UID Only ...
2.3 How to read NFC Tags . Enable the NFC Power option in the NFC Config menu. . Touch the NFC tag to the back of the KDCSLED-HF case and make sure the tag and case are within 5cm of each other.
KOAMTAC will repair or, at its opinion, replace products that prove to be defective in material or workmanship under proper use during the warranty period. KOAMTAC will not be liable in cases (i) in which the unit has been repaired or altered unless done or approved by KOAMTAC, (ii) in which the unit...
Page 12
KDCSLED-HF User Manual ARRANTY During the warranty period, KOAMTAC will repair or replace defective products returned to KOAMTAC warehouse. International customers should contact the local KOAMTAC office or support center. If warranty service is required, KOAMTAC will issue a Return Material Authorization Number.
KDCSLED-HF User Manual 4. Contact Information CORPORATE HEADQUARTERS 116 Village Blvd., Suite 305 Princeton, NJ 08540, USA Phone: 609-256-4700, FAX: 609-228-4373 Email: support@koamtac.com For more information, visit our website - www.KOAMTAC.com Revision 1.1 Copyright®2012-2018, KOAMTAC, Inc.
Need help?
Do you have a question about the KDCSLED-HF and is the answer not in the manual?
Questions and answers