Table of Contents
Advertisement
Quick Links
Hook
Material
High Strength Reinforced Nylon
Colour
Black
Fixing Method Glue
2
1
2
3
Ø100 x 4 BLADE
Set the depth stop to #20 and guide height for substrate
thickness. Plunge in 3 locations then repeat using the Mark-
Out Template, packing the guide 3mm to achieve a 7mm cut.
4
To aid in the installation of the Key and Hook, start by
inserting one end in the slot then use a hammer or
mallet to tap the component flush into place. Ensure
centre lines on substrate align with centre mark on
Hook and offset distance relevent to the Key.
Key
124
7
Biscuit Cut Option
125
From Centre Mark
Align Centre Marks
Mounting
1
Use a Ø7mm router bit to cut a slot in both substrates
where the Hook and Key of the Mini 120 is to be
mounted. Depth needs to be 10mm for each.
3
Apply Striplox Liquidlox 15 second cure adhesive to
both sides of the slot in each substrate.
striplox or call 1800 JOINLOX to find out more about Striplox
Liquidlox and Mark-Out Template.
5
Align Mark and Face
After glue is applied, insert Hook and Key into slot
until flush with substrate. Allow to dry as per glue
manufactures instructions.
Installation Guide
Mini 120 - Metric
Router Cut Option
Ø7mm ROUTER BIT
125
Striplox Liquidlox
Visit joinlox.com/
Page 1
Advertisement
Table of Contents
Summary of Contents for Striplox Mini 120
- Page 1 Ø7mm ROUTER BIT Use a Ø7mm router bit to cut a slot in both substrates Material High Strength Reinforced Nylon where the Hook and Key of the Mini 120 is to be Colour Black mounted. Depth needs to be 10mm for each.
- Page 2 To complete the assembly push the end of the larger than Y. Insert the Hook into the Key with the longer substrate (with X offset) until the Mini 120 is fully X end towards the face to be pushed during assembly.
- Page 3 Option C - Biscuit Cutter To suit 125 cut wheel 58 C/C Notes: Groove detail typical for both Hook and Key halves. Key shown in groove. STRIPLOX JOINLOX® ARE TRADEMARK AND PATENT PROTECTED INTERNATIONALLY Striplox Mini 120 Mounting Data Sheet - Metric 2.1...
Need help?
Do you have a question about the Mini 120 and is the answer not in the manual?
Questions and answers