Advertisement
easy-to-assemble
Easy Adjust Instructions
FOUNDATION ASSEMBLY INSTRUCTIONS
Step 1.
Take all components out of the box
and lay them out on the oor.
Step 2.
Unfold each frame piece, lay on side and attach
six support braces with preinstalled wing nuts.
Step 3.
Tighten the wing nut until secure. Repeat the same
process for all six legs, making sure all wing
nuts are tightly secured.
Step 4.
Flip the base over to stand upright.
Place both frame halves side by side.
Position frames so inside holes line up.
Full, Full XL, Queen, King
for Full, Queen, King and Cal King
FOUNDATION
Step 5.
Install the two screws with spacers on the
so both sides are connected and tight.
Step 6.
Install one screw with spacers on the
so both sides raise together.
Note.
If you want to use the frame as two separate TXL's,
do not install this screw.
Step 6.
Install the two metal guards to prevent the mattress
from slipping o the edge of the frame.
LOWER
frame
UPPER
frame
Advertisement
