Table of Contents
Advertisement
Quick Links
Download this manual
See also:
User Manual
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Viavi Seeker HL
Summary of Contents for Viavi Seeker HL
- Page 1 Seeker HL Source Transmitter User’s Guide...
- Page 2 Copyright/Trademarks © Copyright 2018 VIAVI Solutions Inc. All rights reserved. No part of this guide may be reproduced or transmitted, electronically or otherwise, without written permission of the publisher. VIAVI Solutions and the VIAVI logo are trademarks of VIAVI Solutions Inc. (“Viavi”).
-
Page 3: Table Of Contents
Testing Approach ......................7 Equipment Supplied with the Seeker HL Source Transmitter ..........8 Replacement Parts.........................9 Field Accessories ........................9 A Guided Tour of Your Seeker HL Source Transmitter ............10 Front View ........................10 Rear View ........................11 Left Side View .........................12 Battery Charging ........................13 Battery Charge Indicator LED ..................13... - Page 4 Seeker HL Source Transmitter Page 4 User’s Guide May 2018 Document Num., Rev. 2...
-
Page 5: Chapter 1 General Information
Chapter 1 General Information Ordering Information For additional information about our products and services, contact your local VIAVI representative or visit https://www.viavisolutions.com/en-us/how-buy. Where to Get Technical Support Phone US: +1-844-GO-VIAVI or +1-844-468-4284 Outside US: +1-855-275-5378 Email: Trilithic.support@viavisolutions.com Website: https://support.viavisolutions.com/welcome How this Manual is Organized This manual is divided into the following chapters: •... -
Page 6: Conventions Used In This Manual
The chosen frequency must closely match that of the leakage detector or leaks will not be detected properly. If the Seeker HL Source Transmitter appears to be out of calibration, the unit must be returned to VIAVI or an authorized repair center for re-calibration. -
Page 7: Introduction & Operation
The displayed leakage levels are normalized by the Seeker HL receiver to reflect the value of the leak at nominal systems levels within the subscriber premise. The normalization... -
Page 8: Equipment Supplied With The Seeker Hl Source Transmitter
When utilizing the higher +60 dBmV transmit level the Seeker HL is able to locate signal leakage down to a normalized leakage level of 0.1 uV/m with a single flexible antenna; making it possible to locate and repair signal leakage levels far beyond the measurement range of conventional leakage detectors. -
Page 9: Replacement Parts
Replacement Parts The following replacement parts are available for the Seeker HL Source Transmitter: Part Number Description 0090061000 Li-ION Replacement Battery (Replacement Requires 1 Battery) 0610198000 AC to DC Power Adapter & Battery Charger 0190197000 AC US Power Cable Field Accessories... -
Page 10: A Guided Tour Of Your Seeker Hl Source Transmitter
A Guided Tour of Your Seeker HL Source Transmitter Before using your instrument take a few minutes to familiarize yourself with the instrument, its basic conventions and its navigational tools. This section provides a brief overview of the instrument’s features, buttons, and controls. -
Page 11: Rear View
Rear View RF Output Connector LED Legend Seeker HL Source Transmitter May 2018 User’s Guide Page 11 Document Num., Rev. 2... -
Page 12: Left Side View
Rubber Door In the image above, the DC charge port protective rubber door is in the closed position for illustrative purposes. This door should remain closed when not using this port. Seeker HL Source Transmitter Page 12 User’s Guide May 2018... -
Page 13: Battery Charging
3 hours or to trickle charge the battery while the instrument is in use. Plug the power adapter & battery charger into the DC charge port of the Seeker HL Source Transmitter on the left side of the instrument under a protective cover. -
Page 14: Operation
Once the instrument’s battery is charged, you may startup the Seeker HL Source Transmitter by pressing the ON/OFF button on the front of the device. To shutdown the Seeker HL Source Transmitter, simply press and hold the power button for two seconds. -
Page 15: Chapter 3 Appendix
Output: 15 VDC, 3.3A Environmental Specifications Storage & Storage: -40° to +70° C (-40° to 158° F) Operating Operating: -20° to +50° C (-4° to 122° F) Temperature Seeker HL Source Transmitter May 2018 User’s Guide Page 15 Document Num., Rev. 2... -
Page 16: Limited Warranty
Limited Warranty For the latest warranty information, visit https://www.viavisolutions.com/literature/viavi-solutions-inc-general-terms-en.pdf Seeker HL Source Transmitter Page 16 User’s Guide May 2018 Document Num., Rev. 2... - Page 17 Seeker HL Source Transmitter May 2018 User’s Guide Page 17 Document Num., Rev. 2...
- Page 18 Rev. 2, May 2018 English VIAVI Solutions North America: 1.844.GO VIAVI / 1.844.468.4284 Latin America +52 55 5543 6644 EMEA +49 7121 862273 APAC +1 512 201 6534 All Other Regions: viavisolutions.com/contacts email TAC@viavisolutions.com...
Need help?
Do you have a question about the Seeker HL and is the answer not in the manual?
Questions and answers