Advertisement
LeakAlertor
Testing the LeakAlertor - Easy as 1-2-3
Re-Setting the LeakAlertor
LA6KUG DEC16
6000 User's Guide
®
1)
Press and Hold the
then the
YELLOW
2)
Release the
RESET
3)
Watch the
LED
a)
RED
LED
b)
GREEN
LED
c)
YELLOW
down.
The unit exits
TEST
The unit flashes the
toilet is not actually flushing. Do not test the unit for at least two
to three minutes after you last flushed the toilet.
*(Note: When the water has reached its lowest level in the tank during the flush, the water
turbulence may cause the unit to appears as though the
few seconds. The unit is detecting the rising/falling water height of the turbulence and
alerting accordingly. Once the water height begins to steadily rise, the unit will contine to
flash the green
until the water height stabilizes at the end of the flush.)
LED
1) Press and Hold the
then release it.
2) The unit flashes all three
just the
GREEN
LED
at the same time.
LEDS
3) Flush the toilet any time after all three
complete the reset.
You're all done, the unit has been reset!!
Reset the LeakAlertor to:
Make a repair to the toilet,
Temporarily silence the alerts,
Remove the unit temporarily from the toilet.
button until the
RESET
flashes.
LED
button.
colors while the toilet flushes*:
- as the water goes down,
- as the water fills up,
- when the water isn't going up or
LED
mode automatically after about three minutes.
during
YELLOW
LED
button until the
RESET
s and beeps. The unit flashes
LED
for about a minute then will flash all three
tel: 610.594.2191 |toll free: 877.532.5253
15 E. Uwchlan Ave Ste 412 | Exton, PA 19341
, and
RED
mode when the
TEST
s are flashing randomly for a
LED
flashes,
RED
LED
are flashing to
LEDS
www.leakalertor.com
Advertisement
