Download Print this page

LeakAlertor 6000 User Manual page 2

Advertisement

Using the
RESET
Use the
function to:
RESET
Temporarily silence the alerts
Make a repair to the toilet
Temporarily remove or store the unit
➢ The
button is recessed inside the enclosure as shown in the figure below.
RESET
➢ Use a toothpick or pencil to press the button.
To reset the LeakAlertor:
1) Press and Hold the
2) All three
s will flash once and the unit will beep once.
LED
3) The
will then flash for several minutes, after which all three
GREEN
LED
4) Once all three LEDs are flashing at the same time Flush the toilet to complete the reset.
Testing the LeakAlertor - Easy as 1-2-3
Use the
function to confirm the unit is working as intended.
TEST
➢ While testing the unit, we recommend removing the toilet tank lid to observe the water height in the tank while the
s flash.
LED
Wait at least two to three minutes after you last flushed the toilet to begin a test of the unit.
➢ The unit will automatically exit the test mode after about three minutes
LA6KUGPC67 JUN17A
LeakAlertor
button
button. When the
RESET
You're all done, the unit has been reset!!
To test the LeakAlertor:
1) Press and Continue to Hold the
and then the
2) Release the
3) Flush the toilet and watch the
RED
LED
GREEN
LED
* During the flush cycle and/or when the water has reached its lowest level in the tank during
the flush, the water turbulence may cause the unit to appear as though the
randomly. The unit is detecting the rising/falling water height of the turbulence and alerting
accordingly. Once the water height begins to steadily rise, the unit will contine to flash the
until the water height stabilizes at the end of the flush.
GREEN
LED
6000 User's Guide
®
illuminates, immediately release the
RED
LED
RESET
will illimnate.
YELLOW
LED
button when the
RESET
s during the entire flush cycle*:
LED
– The water level in the tank is falling
– The water level in the tank is rising
tel: 610.594.2191 |toll free: 877.532.5253
15 E. Uwchlan Ave Ste 412 | Exton, PA 19341
RESET
will begin to flash at the same time.
LEDS
button. The
RED
LED
illuminates.
YELLOW
LED
www.leakalertor.com
button.
will illuminate,
s are flashing
LED

Advertisement

loading