Table of Contents
Advertisement
Quick Links
Sensor
pressure
Original operating manual
Version
BA-2016.11.24 EN
Print-No.
300 196
TR MA DE Rev002
Series
PTM C2
ASV Stübbe GmbH & Co. KG
Hollwieser Strasse 5
32602 Vlotho
Germany
Phone: +49 (0)5733-799-0
Fax: +49 (0)5733-799-5000
Email:
contact@asv-stuebbe.de
Internet:
www.asv-stuebbe.com
We reserve the right to make technical changes.
Read carefully before use.
Save for future use.
Advertisement
Table of Contents
Related Manuals for Stübbe PTM C2 Series
Summary of Contents for Stübbe PTM C2 Series
- Page 1 Sensor pressure Original operating manual Series PTM C2 Version BA-2016.11.24 EN ASV Stübbe GmbH & Co. KG Print-No. 300 196 Hollwieser Strasse 5 TR MA DE Rev002 32602 Vlotho Germany Phone: +49 (0)5733-799-0 Fax: +49 (0)5733-799-5000 Email: contact@asv-stuebbe.de Internet: www.asv-stuebbe.com We reserve the right to make technical changes.
-
Page 2: Table Of Contents
Table of contents Table of contents List of figures About this document ....... 3 Target groups . -
Page 3: About This Document
About this document About this document Other applicable documents This manual • is part of the equipment • applies to all series referred to • describes safe and proper operation during all operating To download: phases Resistance Guide Chemical resistance of the materials used Target groups www.asv-stuebbe.de/pdf_resistance/300051.pdf... -
Page 4: General Safety Instructions
General safety instructions General safety instructions The manufacturer accepts no liability for damages caused 2.2.2 Obligations of personnel by disregarding any of the documentation. Only complete work on the device if the following requirements are met: • System is empty Intended use •... -
Page 5: Layout And Function
Transport, Storage and Disposal Layout and Function Transport, Storage and Type plate Disposal P T M C2 Unpacking and inspection on delivery D r u ck sensor M ess b e r e i c h 0 - 10 b a r 1. -
Page 6: Disposal
Installation and connection Disposal Installing device in the process pipework Plastic parts can be contaminated by poisonous or radioac- tive media to such an extent that cleaning will not be suffi- Process pipework has been properly prepared. cient. Process pipework has been secured against unintentional opening with shut-off values. -
Page 7: Operation
Maintenance Operation Maintenance 7.2.1 Removing the device Initial start-up System is empty. System has been flushed. Device is connected properly to the process pipework. System is depressurized. Device is connected properly with the power supply and System has cooled down. ready for operation. -
Page 8: Troubleshooting
Appendix Troubleshooting WARNING Risk of injury and poisoning due to hazardous media liq- uids! Use personal protective equipment when carrying out any work on the device. Error Possible cause Corrective action Medium is leaking Pre-tension of the Retighten out of the flange O-ring too small union nut by hand.
Need help?
Do you have a question about the PTM C2 Series and is the answer not in the manual?
Questions and answers