Installation Instructions - Caloric GTA18B2W Repair Manual

Installation Instructions

Proper installation will ensure this refrigerator operates
most efficiently. Amana cannot be responsible for
improper installation.
1. Remove and reverse doors if necessary.
a. Remove top hinge cover. Remove top hinge.
b. Remove freezer door.
c. Lift door closure off center hinge pin. Remove center
hinge pin.
d. Remove refrigerator door.
e. Remove center hinge bracket.
f. Remove toe grille and bottom hinge cover. Remove
bottom hinge.
5/16" (8 mm) screws
Top hinge
Center
hinge
Caution
To avoid property damage, protect flooring with
cardboard, rugs, or other protective material
when moving refrigerator. Verify stabilizing leg
is raised before moving refrigerator. Raise
stabilizing leg by turning counterclockwise.
g. Slide appliance cart under side of refrigerator. Wrap
refrigerator with blanket or pad. Thread cart strap
around refrigerator and tighten. Do not overtighten
strap. Move refrigerator in front of final location.
h. Reverse doors if necessary.
i. Rehang doors by reversing steps a-f.
• Use a penny at top to space door 3/4" (18 mm)
from cabinet.
Center hinge
pin
Bottom hinge
Phillips
screws
3/8" (9 mm) screws
• Handle side of door should be approximately 1/8"
(3 mm) higher than hinge side.
3/4" (18 mm)
2. Connect ice maker water supply line.
• See instructions on rear of refrigerator cabinet.
3. Plug in power cord.
4. Move refrigerator into final location.
5. Level refrigerator.
a. Remove toe grille. Remove bottom hinge cover if
refrigerator has a stabilizing leg.
b. Turn roller adjustment screw to raise or lower
refrigerator cabinet. Front of refrigerator must be
1/4" (6 mm) higher than back.
c. Turn stabilizing leg (some models) clockwise until
firmly against floor.
Roller
adjustment
screw
Bottom
hinge cover
6. Review "Installation Checklist" in
Owner's Manual with consumer.
4
"
1/8 (3 mm)
Stabilizing leg (some models)