Designplan ICE LED 1.0 Installation Instructions

ICE LED 1.0 - 1.1
Installation instructions
LED
IP67
TECH
!
Please read the following instructions carefully.
IMPORTANT:
Although LED runs on a very low voltage, always cut off the power sup-
•
ply before installing the LED light or subjecting it to maintenance.
Unauthorised alterations or tampering of the product will invalidate all
•
the conditions of guarantee.
This fixture must be istalled by a qualificate electrician.
•
Designplan Lighting is not resposable if its fixtures are not
•
installed in according to local safety standards.
Data contained in this document may be changed at any moment with-
•
out prior notice and do not place Designplan Lighting under any
implicit or explicit obligation.
ELECTRICAL CONNECTIONS:
LED lights run at constant current.
•
LED lights must be connected in series respecting polarities.
•
As for the choice of the power supplies, please consider the current
•
through which they are feeded and the max power consumption of
LEDs you have to install.
The total number of LEDs to be feeded must be counted for each single
•
spot (e.g. 2 spots with 3 LEDs 1W each= 6 LEDs 1W in all= 6W).
The system must be feeded only if all the spots are connected. The
•
connection of the single spots with the power supply in voltage may get
the spot broken due to over-tension in vain.
The power supplies must be installed in aerated rooms, far from heat
•
sources. A situation of overworking or a lack of air circulation will not
permit a natural dissipation.
The electronic power supply is current-stable, therefore it partially com-
•
pensates the voltage-drop problems related to the cable length;
anyhow we suggest not to overcome 30 metres.
Never use switches on secondary circuit.
•
NOTES:
Wire connections must be realized with self amalgamating
•
scotch or similar.
corrugato
T 40°
Ø0.79"
Ta
WARNING!!!
ICE LED 1.0
1.57"x1.57"
2.01"
Designplan Lighting, Inc., 79 Trenton Ave., Frenchtown NJ, 08825. T.908-996-7710 F.908-996-7042
RoHS
compliance
25°
ICE LED 1.1
2.36"x2.36"
2.01"
Designplan Lighting, Inc., 79 Trenton Ave., Frenchtown NJ, 08825. T.908-996-7710 F.908-996-7042