Summary of Contents for OM POWER OM SW 2/10
- Page 1 INSTRUCTION MANUAL OM SW 2/10 OM SW 2/10+ Shortwave plus 50 MHz Antenna switch OM Power, s.r.o. 93030 Báč 126, SLOVAKIA Contact : +421 905 321 410 e-mail: om-power@om-power.com WWW.OM-POWER.COM...
-
Page 2: Important Warnings
OM2000A+ and OM4001A. It is possible to produce antenna switch with combination of OM SW2/10 and OM SW 2/10+ (one side controlled with BCD code) Of course, the antenna switch OM SW 2/10 and OM SW 2/10+ can be used independently from OM Power amplifiers, with various controllers. Features ... - Page 3 Easily mounted on the wall or tower The antenna switch is intended to be used either inside or outside Connecting the switch OM SW 2/10 Antenna switch OM SW 2/10 can be connected directly to the automatic power amplifier OM2200A,...
-
Page 4: Terminal Connection
13. GND - connect-12V terminal of external power supply Connecting the switch OM SW 2/10+ Antenna switch OM SW 2/10+ is designed for OM Power amplifier OM2000A+, OM4001A and can be directly controlled without any additional device, or other type of BCD decoder. Selection of required antenna port is controlled with BCD code (5V logic compatible with YAESU BCD code). - Page 5 OM SW 2/10 requires 2 cables with eleven conductors (ten antennas plus return/ground). OM SW 2/10+ requires 2 cables with six conductors (A B C D ports, +12V and ground). It is convenient to use shielded 8 wire (four pair) cable and two – two wires parallel for 12V supply.
-
Page 6: Specifications
characteristic impedance (for example when it is connected to the thriplexer). Usually, antenna switches are delivered with unconnected X ports. SPECIFICATIONS Frequency range: ................1.7 - 54 MHz Characteristic impedance: ................50 ohm Number of radio ports: ..................2 Number of antenna ports: ................... 10 Supply voltage: ................+12 to +15V DC Selection of port: ............