Download Print this page

TAIYO YUDEN EYSMJCS User Manual page 19

Bluetooth module, rf plus baseband class 2 usb

Advertisement

EYSMJCS
Control No.
HD-AE-C071063
Notes:
a)
Up to seven connections: a slave of up to two masters, and/or a master of up to seven slave.
Some operations restricted or non-functional in a scatternet.
b) Chip resource limits constrain the rate at which ACL and SCO connections can be made and broken to approximately
20 per 15 seconds. The time limit can be configured.
b)
Up to three SCO links. Each SCO link can be routed over the chip's PCM interface or over HCI/BCSP.
Preliminary Support for SCO over USB or H4 is in place, but testing has been light.
d)
No HCI SCO
Host Controller to Host flow control support.
No HCI SCO Host to Host Controller flow control support.
e)
Limited support for "best effort" and "guaranteed" Qos only.
f)
Initial device name taken from PS Keys, and so is maintained through a reset/reboot.
g)
HCI Reset does not work if the device is in local loopback mode.
h)
Optional Paging schemes are not supported.
i)
Remote ACL loopback sometimes deadlocks when the device's flow control mechanisms assert to each other.
j)
Bluetooth v1.1 specification command, deprecated in the v1.2 specification,or later; support retained for backwards co
mpatibility.
k)
Bluetooth v1.1 specification command, renamed in the v1.2 specification,or later.
Park Mode ---> Park State
Exit Park Mode ---> Exit Park State
Set Host Controller To Host Flow Control ---> Set Controller To Host Flow Control
Change Local Name ---> Write Local Name
Read SCO Flow Control Enable ---> Read Synchronous Flow Control Enable
Write SCO Flow Control Enable ---> Write Synchronous Flow Control Enable
Get Link Quality ---> Read Link Quality
l)
Command not in the Bluetooth v1.1 specification.
m) Underlying Flow_Specification functionality the same as for QoS_Setup.
n)
Command which rewrites FROM in module
p)
CVSD not available with 3EV3 or 3EV5 EDR packets.
q)
HCI Setup Synchronous Connection command does not support HV1,HV2 and HV3 Packet Type. If you want to use those
Packet Types, please use HCI Add SCO connection command
Control name
(8/13)
Electrical characteristics
.
TAIYO YUDEN
24-Aug.-2007 Ver.0.1
TAIYO YUDEN Confidential
& Tentative
19/40

Advertisement

loading