Initial Mdr Configuration Steps - HighSecLabs RS20N-3 User Manual

SEC TIONS
Table of Contents
oPeRaTIoN

Initial MDR Configuration Steps

Table 02 describes the initial MDR configuration steps.
# Action Action Description
1 Install Smartcard verify that the applications, drivers and files of the cryptographic software (CSP) that
applications corresponds to your selected smart card vendor are installed on all the computers that
you plan to connect to the MDR.
Note: Perform a computer restart in case needed to complete the smartcard application
installation.
2 Select MDR operational Mode selection is controlled by a hardware dual in-line package (DIP) switch.
operational Mode
led auto association is the default mode.
In this mode, PIN number 2 is pulled down and other PINs are up.
Note: Read the understanding the MDR operational Mode section for further details.
3 Turn PC oN Make sure that all the PCs are turned oN.
4 Connect MDR to Connect the MDR to Power
Power
5 Connect uSb Connect the MDR uSb cables to the computers. Cable numbers correspond to the
Cables to PCs numbered MDR buttons.
6 Insert Smartcard Insert your smartcard into the MDR reader socket.
into the MDR
Note: Make sure the smartcard chip is facing away from you.
7 Initial association Press PC Number button#1 to initialize the MDR on PC#1.
with PC#1
HSL RS20N-3 (MDR102) / RS40N-3 (MDR104) Secure 2/4-Port Multi-Domain Smart Card Reader User Manual
1 2 3
Expected Behavior
1 second beep sound.
all PC association led lights blink once.
all PC Number led lights blink constantly.
1 second beep sound.
all lights are off.
PC Number button#1 light turns oN.
PC association led#1 blinks and then turns oN.
The MDR appears as a smartcard reader under PC#1 device
manager.
4
7