Apco FullView Series Assembly Instructions

FullView Kiosk Series
Prepare Kiosk for Base Attachment
1. Remove the base plate from the carton
and remove protective packing materials.
Caution: Steel plate is heavy, take
precatutions to prevent dropping.
Set aside.
2. Remove kiosk from the carton and leave
protective channels in place until base is
secured. Place the kiosk across the
shipping carton.
3. Use the (4) phillips head machine screws
to attach base plate to kiosk as shown
(Fig 1).
4. Stand kiosk upright and remove
remaining packing materials.
Kiosk Clear Lens Removal
1. Use the Magnetic Tool to remove Locking
Pin. Access the Locking PIn by removing
green tape at top right hand corner of
kiosk. Place the magnet over the steel
pin as shown in Fig 2.
Should the pin be difficult to magnetically
remove, shift Clear Lens (CL) to the left
using the SCT.
2. Use the SCT to shift the CL to the RIGHT.
The LEFT side of the CL will release from
the vertical edge.
3. Set aside CL. A special low tack tape to
hold and position graphic insert is located
at the top center of the display area. Peel
the white liner on the tape and position
graphic. Press across the tape area to
secure graphic while replacing the CL.
4. Replace CL using SCT, inserting acrylic
into the right side vertical edge. Secure
the lens by compressing special
'cushions' on the right side until lens is flat
against graphic. Release CL and the
cushion will shift the lens left and under
the vertical edge. Replace Locking Pin.
388 Grant Street, SE, Atlanta, Georgia USA 30312-2227
Steel Base Plate
Low tack tape
for graphic
Suction Cup Tool
(SCT)
Clear Lens
Clear Lens
Base Plate
Telephone (404) 688-9000
Assembly
Instructions
Protective channel
Crate
2.
Web: www.apcosigns.com
11/3/2016
Fig 1
1.
Fig 2
IS459