DCS -559 Quick Start Manual

DCS-559 ROUTER
Embedded Cellular Router with 802.11
QUICK START GUIDE
FCC Statement:
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC/IC RF Radiation Exposure Statement Caution: To maintain compliance with the FCC's RF
exposure guidelines, place the product at least 20cm from nearby persons.
Direct Communciation Solutions
10675 Treena Street, Suite 103
San Diego, CA 92131
For Technical Assisstance
Email: support@dcsbusiness.com

Package Contents

•
DCS-559 Embedded Cellular Router with 802.11
• Power adapter
• RJ45 Ethernet cable
• Cellular Antenna
• Wireless Antenna
• Quick Start Guide

Quick Router Setup

Step 1: Connect the Cellular Antenna and Wireless Antenna to the
DCS-559 Router.
Step 2: Connect the power adapter to the DCS-559 Router.
Step 3: Connecting to a PC using a RJ45 Ethernet cable
from the LAN port of the DCS-559 to a PC.

Web Management

Step 1: Open a web browser and type http://192.168.1.1
in the address bar and press Enter.
Step 2: Configure connection popup by typing
User name: admin and Password: password.
Step 3: DCS-559 Web User Interface
1