Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for No Wires Needed Pelican 1100
- Page 1 No Wires Needed Pelican 1100 WLAN Hub User Manual Version 2.1.1 – October 1999...
- Page 3 User manual Pelican 1100 WLAN Hub No Wires Needed Jan Steenlaan 3-5 3723 BS Bilthoven The Netherlands www.nwn.com Version 2.1.1 – October 1999...
- Page 4 Swallow, Parrot, Pelican, AirLock, APCenter, ASBF and Connect are trademarks of No Wires Needed. Other product and company names are registered trademarks or trademarks of their respective holders. Copyright statement...
- Page 5 Free Repair Period NWN undertakes a Free Repair Period of 12 months from the date of Invoice. Within the Free Repair Period NWN repairs a faulty device free of charge or replaces it in case of irreparable damage. Excluded from the Free Repair Period are malfunctions caused by operation outside the intended usage;...
- Page 6 Statement of Year 2000 Compliance Detailed information about our statement is published on our website. http://www.nwn.com...
- Page 7 FCC Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with the minimum distance between your body, excluding hands, wrists, feet and ankles, and the antenna as shown in the table below: WLAN Hubs which use the attached low 20cm (7 inches) gain indoor antennas (1.9dBi)
- Page 8 (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. No Wires Needed Parrot, Pelican, WBS, WBC 1100 Tested To Comply With FCC Standards...
-
Page 9: Table Of Contents
Connection the devices ..............15 Connect one device to the Pelican..........15 Connect 2-4 devices to the Pelican..........16 Continue installation..............17 4.3.1 Resetting the Pelican............18 Technical specifications Pelican 1100 ..........19 Standards supported..............19 Environmental ................19 Power specifications ..............19 Radio specifications ..............19 Specific features .................20 Physical Dimensions..............20... -
Page 10: Introduction
No Wires Needed 2 Introduction Thank you for purchasing your No Wires Needed Pelican 1100 WLAN Hub. This manual will assist you with the installation procedure. The package you have received should contain the following items: • User manual •... -
Page 11: Configuring The Pelican
PConfig setup.exe. The set-up wizard will guide you through the installation process. Figure 3.1 Select the directory you want to install PConfig in. Start the PConfig program after completion of the installation. User Manual Pelican 1100 WLAN Hub Page 11 of 11... -
Page 12: Give The Pelican An Ip-Address
Note: You should not attach the Pelican to the same wired backbone were the Access Points are connected to. This will result in a not-ending loop, and can cause network problems. After starting Pconfig the following screen will appear. Page 12 of 12 Pelican 1100 WLAN Hub User Manual... - Page 13 You are now enabled to fill in the System name, System Location and Contact Info. These fields are not mandatory; the information is useful when using several Pelicans in a more complex environment. Place your cursor behind the field you wish to change. User Manual Pelican 1100 WLAN Hub Page 13 of 13...
-
Page 14: Selecting A Network
Check the box “Use DHCP or BOOTP to obtain an IP-address” and press “Apply”. Note: The IP address previously entered will remain in the “IP address or DNS name” box, even when DHCP or BOOTP is selected. Page 14 of 14 Pelican 1100 WLAN Hub User Manual... -
Page 15: Connection The Devices
Note: The Pelican 1100 WLAN Hub is equipped with one RJ45 connector. Use a cross-cable if you only connect one device to the Pelican 1100 WLAN Hub. If you want to connect four devices, be advised to use a normal standard hub connected to the Pelican and the four devices. -
Page 16: Connect 2-4 Devices To The Pelican
No Wires Needed 4.2 Connect 2-4 devices to the Pelican Place your Pelican 1100 WLAN Hub next to the standard Hub. Make sure the antennas are in a vertical position (if not, rotate over 90 degrees). Insert the power connector. -
Page 17: Continue Installation
When the supplied power is too low or unstable the power LED will turn red. The power LED will also turn red when the firmware of the Pelican WLAN Hub has a fault condition. Installation completed. User Manual Pelican 1100 WLAN Hub Page 17 of 17... -
Page 18: Resetting The Pelican
Pelican WLAN Hub on. When you push a paperclip in the reset hole while the Pelican WLAN Hub is switched on, only the lock set by PConfig™ is deactivated. Page 18 of 18 Pelican 1100 WLAN Hub User Manual... -
Page 19: Technical Specifications Pelican 1100
No Wires Needed 5 Technical specifications Pelican 1100 5.1 Standards supported − Compliant with ETS 300 328 and ETS 300 826 (CE marked) − IEEE 802.11 standard for Wireless LAN − All major networking standards (including IP, IPX) 5.2 Environmental Operating temperature (ambient): −... -
Page 20: Specific Features
AirLock™ security, 128-bit key length Utility Software: − PConfig™ configuration tool Key Management: − Automatic Dynamic Key Allocation (ADKA) through public key 5.6 Physical Dimensions 180 x 220 x 40 mm Page 20 of 20 Pelican 1100 WLAN Hub User Manual... - Page 21 No Wires Needed User Manual Pelican 1100 WLAN Hub Page 21 of 21...
- Page 22 No Wires Needed Page 22 of 22 Pelican 1100 WLAN Hub User Manual...
- Page 23 No Wires Needed User Manual Pelican 1100 WLAN Hub Page 23 of 23...