Advertisement
Quick Links
Advertisement
Summary of Contents for Meissner Signal Shifter EX
- Page 2 INSTRUCTIONS FOR INSTALLATION AND OPERATION OF THE MEISSNER SIGNAL SHIFTER MODEL EX INTRODUCTION The power output on all bands is The MEISSNER SIGNAL sufficient: 1. To drive a low or medium SHIFTER variable frequency powered amplifier, using triodes. 2. To...
-
Page 3: Installation
MEISSNER > > > > SIGNAL SHIFTER= = = = Selection of the desired amateur band is accomplished by rotating the Space Limitation coil turret with the band switch knob on the front panel. The SIGNAL SHIFTER should be installed to allow free circulation of air. Output frequency on any band is Nothing should be placed on or too continuously variable by means of the... - Page 4 MEISSNER > > > > SIGNAL SHIFTER= = = = The number of turns in the link is The >AUTOMATIC= terminals at very important in the proper impedance matching of the SIGNAL SHIFTER to the rear of the SIGNAL SHIFTER chassis and the ΑAUTO= position of the the driven stage.
- Page 5 MEISSNER > > > > SIGNAL SHIFTER= = = = A check should be made before are: actual operation is begun, to be sure 80 Mtrs. 20 Mtrs. that harmonics are not being radiated, 40 Mtrs. 15 Mtrs. although the coupling methods shown 10 &...
- Page 7 MEISSNER > > > > SIGNAL SHIFTER= = = = Assuming that SIGNAL may either be left out of the key jacks or SHIFTER has warmed up and is tuned plugged in with the shorting bar on the to the desired frequency, the 4 - posi- key closed.
-
Page 8: Service Notes
MEISSNER > > > > SIGNAL SHIFTER= = = = In using the SIGNAL SHIFTER as an exciter or as a transmitter, it will MEISSNER SIGNAL usually be possible to shift frequency SHIFTER is equipped with a glass over a moderate range without retuning 6V6GT/G tube. - Page 9 MEISSNER > > > > SIGNAL SHIFTER= = = = Step 2- Turn the band switch to the 10 meter band and, without touching Note: The calibration charts in the back the tuning dial, adjust trimmer C2 of this book were made with the 80-40- with a screw driver to obtain the 20-15 and 10-11 meter bands in the maximum closing of the tuning...
-
Page 10: Standard Warranty
MEISSNER > > > > SIGNAL SHIFTER= = = = STANDARD WARRANTY This SIGNAL SHIFTER was carefully tested, inspected, and packed in an approved shipping container and left our factory in perfect condition. Should any damage occur while in transit, file claim with carrier at once. - Page 11 MEISSNER > > > > SIGNAL SHIFTER= = = = CALIBRATION SHEETS 80 MTR. BAND 40 MTR. BAND 20 MTR. BAND 15 MTR. BAND FREQ.KC. DIAL FREQ.KC. DIAL FREQ.KC. DIAL FREQ.KC. DIAL 3430 6860 13720 20600 3450 6900 13800 20900 3500 7000 13900...
- Page 12 MEISSNER > > > > SIGNAL SHIFTER= = = = CALIBRATION SHEETS 6 MTR.BAND 10-11 MTR. BAND 160 MTR. BAND 75 MTR. PHONE BAND (12 MTR. OUTPUT) FREQ.KC. DIAL FREQ.KC. DIAL FREQ.KC. DIAL FREQ.KC. DIAL 26600 1715 3773 24500 26800 1720 3800 25000...
Need help?
Do you have a question about the EX and is the answer not in the manual?
Questions and answers