Before Using Your Battery Charger; Assembling Your Charger - Sears 200.71450 Owner's Manual

Before Using Your Battery Charger

It is important to prepare your charger for use. This section will tell you how to assemble the charger, ground
and connect the power cord, and prepare to charge a battery.

Assembling your charger

It is important to fully assemble your charger before
use. Follow these instructions for easy assembly.
PARTS:
Two 10-32 thread cutting
screws
Two 1 ¦ -20 thread cutting
4
screws
Two wheels
One axle
Two axle caps
Two axle brackets
One handle
One mounting foot
To attach the axle assembly:
1. Remove charger from packing materials and place
upside down on a flat surface. Attach mounting foot
and secure with the two
2. Hold axle upright on floor or work surface. Then,
using a hammer, tap one of the plastic hubs onto
the top end of the axle. Be sure to tap the hub on
straight. Slide both wheels onto the axle with the
hubs facing inward.
Sch 517
TOOLS NEEDED:
3 ¦ " wrench
8
(for mounting foot)
5 ¦ " wrench
16
(for wheels)
Hammer
Phillips screwdriver
1 ¦ -20 thread cutting screws.
4
4