MERCHSOURCE ULTRASONIC DIFFUSER BLUETOOTH Manual

ULTRASONIC DIFFUSER BLUETOOTH 360ml

Contents:

Ultrasonic Di user
Power Adapter
Remote Control
3 Essential Oil Bottles

Basic Setup:

1. Plug the power cord into the power port on the bottom of the
di user.
2. Fill the tank with room temperature water. Do not ll past the
maximum ll line. Distilled water is recommended.
3. Add 4-5 drops of essential oils. Add more drops for a stronger
scent.
4. Put di user lid in place.
5. Place di user in desired location. Do not place anything on di user
or place di user under anything.
6. Plug adapter into power source, making sure that cable is not a
tripping hazard.
7. Press power button on the underside or use the remote (see
"Remote Control" on the following page).
8. Place decorative cover on di user.
• When the di user is turned on, colorful LEDs will cycle through a
spectrum of colors.
• Di user will automatically shut o when water level gets too low.
• After auto shut o , the lights and music can be turned back on
without re lling tank.
• Remember to remove the power cord when not in use.

Timer:

After the di user is turned on, pressing the power button will
activate one of the timer modes. Select 1, 3, or 6 hours.

Remote Control Batteries:

The remote uses a CR2025 button cell battery (included). To
replace this battery when it is exhausted, follow these steps.
1. Slide out battery tray.
2. Remove old battery and replace with new battery. Be
certain that the battery is positioned so that the smooth side (+)
is towards the back of the remote.
3. Close battery tray and secure.

Functions

Use the remote to control the di user's advanced features.
Mist – When the power button is turned on, the mist is
continuous. Press the mist button once to engage
intermittent mode, press again to turn mist o .
Light – Turns on the light. The color will slowly shift in a
soothing pattern. A second press will freeze the color at
its current hue. Additional presses will cycle through a
range of colors that will not change. The pale color after
red is the shifting color mode. Hold for 3 seconds to turn
this feature o .
Brightness – Progressively dims the light. The third push
will restore full brightness.
Power – Turns the di user on or o .
Audio – Choice of two soothing tunes or two sets of
nature sounds. Cycle through the options by pushing this
button. Hold for 3 seconds to turn this feature o .
Increase/Decrease Volume – Adjusts sound level.
Timer – Set the di user to shut o after 1, 3 or 6 hours.
An indicator light, visible when the ceramic shell is
removed, will indicate which mode is selected.
Note: The di user will shut down if the water is depleted
before the timer expires.
Page 1
Max Fill Line
Timer Mode
Indicator
1 / 3 / 6 hrs
Audio
Mist
Increase Volume
Light
Decrease Volume
Brightness
Timer
Power
Power
Indicator
Printed in China