Cure It Data Sheet - Cure It GRP Installation Manual

General information

Cure It Data sheet

Product description
A Cure It GRP roof is a single-ply GRP laminate consisting of Cure It Roofing Resin and Reinforcement Mat applied in situ over a good quality
OSB3 deck. The roof is finished with pre-formed GRP edge trims and a coat of pre-pigmented Cure It Topcoat.
Material features
- Materials are specially formulated for roofing applications
- 20 year guarantee on materials
- Fast 'wet-out'
- Low styrene emission
- High flexibility
- Adjusted for seasonal variations in temperature
- Good topcoat bonding characteristics
- Includes technical support
- Full training and on-site support available
- Supplied pre-pigmented Graphite Grey (BS 00 A 13)
- Range of colours available
- Fire retardant to BS476-3:2004 (no restrictions on usage)
- Suitable for foot traffic applications with 600g/m² Reinforcement Mat
Longevity
The Cure It roofing system materials (Cure It Roofing Resin, Cure It Roofing Topcoat, Roofing Edge Trims, Hardener, Reinforcement Mat) will
remain within the specification of the Cure It Material Safety Data Sheet when stored correctly and will form a structural waterproof membrane
that will remain watertight for a period of 20 years from the date of manufacture when installed as specified in the conditions set out in the
Cure It guarantee.
Properties in relation to fire
A flat roofing system comprising of a Cure It GRP laminate with Cure It Topcoat when tested to BS 476-3 : 2004 was designated EXT.F.AB
(no limitations on use). F.AA rating is available with the exposed aggregate finish.
Resistance to wind uplift
The Cure It GRP roofing system is fully-bonded to the roof substrate. The system will be resistant to any wind uplift that could reasonably be
expected during the product's lifespan.
Areas of usage
The Cure It waterproofing system can be used for waterproofing applications of almost any size or complexity.
Warm roof specification
The Cure It system can be specified to comply with current part 'L' regulations. (see page 24)
Resistance to foot traffic
In standard 450g/m specification the Cure It system will be resistant to any level of foot traffic that it could reasonably be subjected to during
2
its lifespan. 600g/m specification is available for applications subject to heavy foot traffic such as walkways/balconies.
2
Finish options
The Cure It waterproofing system is supplied to BS4800 00 A 13 Graphite Grey. There are two non-slip options available: exposed aggregate
(granulated non-slip slate coating applied at 0.75kg/m ) and coated aggregate finish (granulated non-slip slate coating applied at 0.15kg/m ).
2 2
Standard Specification
OSB3 18mm T & G
Cure It Roofing Resin @ 1.5kg/m
2
Cure It approved Reinforcement Mat
Cure It Roofing Topcoat @ 0.4kg/m
2
Cure It Hardener (1-4%)
Cure It GRP edge trims
Trim adhesive applied around the perimeter
Applied as per the Cure It Installation Manual
4