One Life 3 Series Assembly Manual

One Life 3 Series Massage Chair
Assembly Guide
No tools required
Step 1.
Lift the top of the box off. Cutting the cardboard is not
required.
Remove the cardboard panels from inside the box and take
away the styrofoam.
Lift out the plastic bag containing the instruction manual
and a head cushion. Place it to the side.
Put the instruction manual in a safe place for future
reference. We recommend reading the manual before
operating the chair.
Step 2.
Unwrap the plastic from the chair. Do not use scissors.
Lower the plastic around the base of the chair, so the chair
can be safely lifted out of the box.
This chair is very heavy and we advise for two or three
people to complete the lift together. Lift the chair out of
the box and onto a flat floor.
Take care when lifting so you don't injure your back.
Step 3.
Now the chair is on a flat surface, grab the backrest and
raise it so it is upright and clicks into place.
The chair will now look the same as in the image to the
right.
The remote control is in a styrofoam box stored in the foot
massager. Take the remote out of the styrofoam and place
the remote on the seat of the chair.