Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for TRANSTEK LS502-E
Summary of Contents for TRANSTEK LS502-E
- Page 1 1.0 Digital Tape Meter LS502-E print date: 8/2012...
-
Page 2: Device Structure
Device structure Before using 1. Install the data bridge. Please refer to the data bridge instruction manual. (If data bridge is already installed, skip these steps.) 2. Register for an account at www.profileplan.net and click "Create Account". Follow the instructions on screen. Measure key Body measurements Data store... -
Page 3: Register Device
Register device 1. Log into your account at www.profileplan.net and choose "My Account" > "Devices." 2. Enter your device’s serial number & click "Add Device." 3. If successful, the device will display as "Active." 4. See "Activate the Product" on the following pages if device does not display as synced. -
Page 4: Install Batteries
Install batteries Activate the device 1. Bring the device within 3 feet of the data bridge. Slide off the battery cover Install 2 AA batteries according to the according to the arrow direction. marks in the battery compartment. 2. Press the power button for 5 seconds. -
Page 5: Operating Instructions
Operating instructions 3. The screen will appear. Wait for the screen appear. If this screen does not display, see trouble shooting. 1. Power up the unit, press the select key to cycle through the measurement location options 2. Gently pull out the tape to start measuring. -
Page 6: Symbol Meaning
Cautions 5. The data, including those failed to be sent before, will be automatically sent to To prevent the product from harming users and to prolong the data bridge. After the data is sent the product life, please follow guidelines below. unit will turn off automatically. -
Page 7: About The Device
About battery use About the device Keep measuring at the same time of every day. For 2 x AAA batteries are required for this product. example, before you go to bed. Measure and check the data corresponding to the part you If the product is not used for extended periods of choose. - Page 8 Cleaning Use a damp cloth to gently clean the device. Dry the device after cleaning it.
-
Page 9: Troubleshooting
Trouble shooting LCD error code No Display Symptom 1. Wireless communication is interrupted Reason/ Low charge Install new batteries Network failure 2. The product is too far away from Cause the data bridge during activation Wrong battery Solution Align polarity symbols (+/-) Re-activate the product within 3 feet of the data bridge installation... - Page 10 LCD error code When using the device, the LCD displays Symptom Reason/ Product is still Data bridge limit of 16 devices Wide Band failure. The data Low battery has been reached Cause not registered. bridge’s WAN LED light flashes Go to www.profileplan.net and Register the Solution Check the internet connection...
- Page 11 When using the device the LCD displays When using the device, the LCD displays Symptom The wireless The system can't automatically The product is out of communication between Reason/ identify the measurement data and wireless transmission the product and data Cause exceeds the identification range range...
-
Page 12: Specifications
The platform of the Health Center can't indicate Symptom Item Parameter the measurement data normally. Product Name Digital Tape Meter LS502-E The measurement data Whole Size 3 x 2.6 x 1.5 inches Wide Band failure. is near or over the The data bridge’s... - Page 13 This device complies with Part 15 of the FCC Rules. used in accordance with the instructions, may cause harmful Operation is subject to the following two conditions: (1) this interference to radio communications. However, there is no device may not cause harmful interference, and (2) this guarantee that interference will not occur in a particular device must accept any interference received, including installation.
Need help?
Do you have a question about the LS502-E and is the answer not in the manual?
Questions and answers