Motorline TEC 1 User Manual And Installer Manual

EN
TEC 1
USER MANUAL/INSTALLER
This is a dual channel transmitter that is activated only after having entered a suitable
combination.
The units are designed for installation in indoor or outdoor locations. That ensures the utmost
v1.1
security because the transmitted code is changed at each transmission session.
REV. 05/2015
The estimated transmission range is 200 m in open space and 35 m indoors.
The units are designed to ensure battery life equivalent to an estimated 2 years of operation
considering 10 transmissions per day.
WARNINGS
• Note that automatic gate and door systems must be installed exclusively by qualified technical
personnel in full compliance with statutory legislation.
• Before starting the installation procedure check that the values given in the "Technical
Specifications" chapter are compatible with the application.
• This product has been designed to control door openers, gate openers and similar mechanisms.
Any other use of the product will be considered improper.
Audible signal
1 short beep
1 long beep
3 long beeps
5 short beeps
10 rapid beeps
INSTALLATION
Before physically installing the unit it is good practice to perform a practical test to assess their
functionality and effective range.
Consider that range may be up to 25 or 30% less when battery power is low.
POSITIONING
Apart from the distance from the receiver, the units should not be positioned in the vicinity or in
contact with metal structures, which could otherwise exert a signal shielding effect. Thanks to
the enclosure protection rating of IP 54, the digital selectors can be installed outdoors if required.
Status
Keypad tone
Auto power-off
Modification of combination confirmed
Error during combination input or combination edit operation
Battery low warning signal New batteries required