Summary of Contents for elv LS 50
- Page 1 Programmable Soldering Station LS 50 User Manual ELV Elektronik AG • Postfach 1000 • D-26787 Leer • Telefon 0491/600-888 • Telefax 0491/6008-244...
-
Page 2: Table Of Contents
Introduction List of contents Dear customer, First of all we should like to thank you for purchasing Page this product. Introduction ..................2 You have, with this soldering station, acquired a product whose design Proper Use ..................2 and construction are completely state-of-the-art. To ensure safe List of Contents ................ -
Page 3: Safety Instructions
With the LS 50 it is possible not only to adjust the set point temperature Always be sure to protect your eyes and body from solder splashes by means of the „+” / „-” keys but also to program up to three by wearing suitable goggles and clothes. -
Page 4: Brief Summary Of Instructions For Use
The soldering iron on the LS 50 operates with 48 W. It can thus heat was switched off the last time. The LCD shows the current actual up to the desired working temperature very quickly and with plenty of temperature in the main display section and the „Power”... -
Page 5: Modifying The Programmed Set Point Temperatures
The device is shipped with the manual standby function disabled. If An arrow above one of these keys signals that the assigned programmed you prefer to have this function enabled, the LS 50 must first be temperature has been activated as set point; (see Figure 2). -
Page 6: Timer-Controlled Standby Function
8. Automatic power-off function The timer-controlled standby function has the effect of lowering the It is also possible to program the LS 50 so that the soldering iron, after working temperature automatically after expiry of a programmable a programmable timeout, automatically switches off. The LS 50 timeout. -
Page 7: Switching Over Between °C And °F
Now key „T2” must be pressed. In the display „CAL 350” appears. The ° ° LS 50 begins to heat up the soldering iron to 350 °C. If there is a 10. Switching over between C (Celsius) and F (Fahrenheit) If you prefer to have the temperature displayed in °F, the LS 50 must... -
Page 8: Handling
The soldering iron attains working temperatures in the range from The LS 50 is fitted with a slow-blowing fine-wire 1 A fuse. In the 150 °C up to 450 °C. Contact with any of its metallic parts may event of a failure, this can be easily exchanged but before doing cause serious burns to people or animals. -
Page 9: Disposal
Disposal In the event that the LS 50 has become unusable, it must be disposed of in accordance with the applicable statutory regulations. Troubleshooting You have, with this soldering station, acquired a product whose design and construction are completely state-of-the-art and whose operation is completely reliable.
Need help?
Do you have a question about the LS 50 and is the answer not in the manual?
Questions and answers