Advertisement
BEFORE FIRST USE
NOTE:
1. The kettle must only be used with the supplied power base.
2. Remove all the packaging material.
3. Place the power base on a dry level surface.
4. The kettle must be washed and rinsed thoroughly before first use.
USING THE CORDLESS KETTLE
1. Place the kettle on a flat surface.
2. Press the lid opener (4) on the handle to open the kettle. Fill the kettle with
water as per the water level indicator. Do not overfill the kettle. The filled
water capacity must be in between the 1.7L (MAX) and 0.5L (MIN). If the
kettle is overfilled boiling water may be ejected.
3. Close the lid by releasing the lid opener on the kettle. Place the kettle flush
on the base.
Electrical connection
4. Switch the kettle on using the on/ off switch. The indicator light will
illuminate.
5. The kettle will switch off automatically when the water is boiled.
6. Disconnect the kettle from the main power supply.
7. Always hold the lid closed when pouring water.
CAUTION: Beware of scalding!
CAUTION: Heating element surface is subject to residual heat after use.
DESCALING
"Furring" is a common problem in hard water areas, therefore the kettle should
be regularly descaled.
1. To descale, fill the kettle with 1L cold water and add approximately 75ml
vinegar.
2. Boil the water and allow it to stand overnight.
3. Re-boil the water the next day.
4. Discard the re-boiled water and refill the kettle with fresh water.
5. Boil the fresh water. This boiled water must also be discarded.
NOTE: Normal commercial descalers for kettles may also be used. Follow the
commercial descaler instructions carefully.
3
Advertisement
