Advertisement
ant
works
Installation Ant Bar (Date: Dezember 2012)
The Ant Bar is an optional Chin Up Bar for the Strong Ant I Trainingboard. To hook the Ant Bar at the Strong
Ant I there must be two anchor bushs pressed into the outer, upper holes. The instruction therefore you can
find on the next side of this paper.
You need to adhere to the following advice for mounting and training with the Ant Hill:
Check before every training session that all bolts are still tight. If there is the slightest indication that the board
could become loose or even starts to wobble it must not be used for training until until all bolts are tightened
and there is no movement of the board.
Make sure that both hooks are in the correct position in the anchor bushs
We are not liable for damages or injuries due to not conforming to the instructions in this manual.
If you have question regarding the installation or anything else, please feel free to contact us.
contact:
info@antworks.at
+43 660 50 96 239
We wish a good success with your new Ant Bar Chin Up Bar and your Strong Ant I
The antworking team
antworks -Installation Instruction - Ant Bar
Side 1
Advertisement
Table of Contents
Related Manuals for Antworks Ant Bar
Summary of Contents for Antworks Ant Bar
- Page 1 Installation Ant Bar (Date: Dezember 2012) The Ant Bar is an optional Chin Up Bar for the Strong Ant I Trainingboard. To hook the Ant Bar at the Strong Ant I there must be two anchor bushs pressed into the outer, upper holes. The instruction therefore you can find on the next side of this paper.
- Page 2 Place the bolts again and make sure that you tighten the bolts well. To hook the Ant Bar you have to put the bar with the Next and last step is to put the both black pins into little hooks on the top of the beam into the anchor the designated holes.
Need help?
Do you have a question about the Ant Bar and is the answer not in the manual?
Questions and answers