Identify Drive Command - Seagate ULTRA ATA ST310212A Product Manual

24
Command name
Write Multiple
Write Sectors
ATA-standard power-management commands
Check Power Mode
Idle
Idle Immediate
Sleep
Standby
Standby Immediate
ATA-standard security commands
Security Set Password
Security Unlock
Security Erase Prepare
Security Erase Unit
Security Freeze Lock
Security Disable Password

3.1.2 Identify Drive command

The Identify Drive command (command code EC
about the drive to the host following power up. The data is organized as
a single 512-byte block of data, whose contents are shown in the table
on page 25. All reserved bits or words should be set to zero. Parameters
listed with an "x" are drive-specific or vary with the state of the drive. See
Section 1 of this manual for default parameter settings.
The following commands contain drive-specific features that may not be
included in the Draft ATA-5 Standard.
U10 Family Product Manual, Rev. A
Command code (in hex)
C5
H
30 31
H,
98 or E5
H
97 or E3
H
95 or E1
H
99 or E6
H
96 or E2
H
94 or E0
H
F1
H
F2
H
F3
H
F4
H
F5
H
F6
H
) transfers information
H
H
H
H
H
H
H
H