FDK AZ003 User Manual

SENSOR LOGGER
AZ003
User's Manual
 Thank you for purchasing an SENSOR LOGGER AZ003.
 For safe and proper use of the product, please read the Manual
prior to use.
 Keep the Manual in a safe place for future reference.
Doc. No. MT-H4-170001 Rev.2.0
Safety Precautions
Observe the safety precautions since they intend to prevent
personal injury or property damage.
 The following symbols indicate the different levels of injury or
damage that may result if the guidelines are not observed and
the product is used improperly.
Indicates a potentially hazardous
WARNING
situation which, if not avoided, could
result in death or serious injury.
Indicates a potentially hazardous
situation which, if not avoided, may
CAUTION
result in minor or moderate injury, or
property damage.
 The following symbols indicate specific directions.
Indicates prohibited actions.
Indicates compulsory actions in accordance with
instructions.
WARNING
Do not disassemble or modify the equipment.
Doing so may cause fire, burns, injury or electric shock.
If you notice anything unusual about the equipment,
immediately stop using.
If you notice anything unusual about the equipment such
as an unusual odor, overheating, fuming, immediately
power off the equipment and stop using.
1
Do not leave the equipment in hot place.
Doing so may cause internal battery to ignite, burst, or
leak.
Do not throw the equipment into fire.
Doing so may cause internal battery to burst.
Do not wet the equipment and do not touch the
equipment with wet hands.
The equipment is not waterproof. When the liquid enters
the inside of the equipment, doing may cause failure, fire,
or electric shock.
If the liquid or other foreign materials enter the
interior of the device, immediately stop using.
Doing may cause fire, or electric shock.
Do not use the equipment without battery cover.
Doing so may cause fire, or electric shock, and failure of
equipment.
Turn off the equipment in airplane.
The use of the equipment in airplane is prohibited.
Do not use the equipment in a place (e.g., hospital)
where the use is prohibited.
Doing so may affect electronic equipment and electronic
medical equipment.
CAUTION
Do not use or store the equipment in the following
locations.
• In hot places (e.g., by the fire, near a heater)
• In humid places
• In the magnetic field
2018/10/03
• In the place that static electricity produces
• In the place that a strong shock produces, or the
place where the strong vibration occurs
• In corrosive gas (e.g., Cl
• In the place where a liquid (e.g., water, oil, or
organic solvent) hangs
• In the place with many dusts
Do not store in places which are exposed to direct
sunlight.
Doing so may cause failure of equipment.
Keep the equipment out of the reach of babies and
infants.
Failure to do so may cause accidental swallowing or
injury.
Do not give a strong shock or drop it on a hard thing.
Doing so may cause failure of equipment.
Do not apply a load such as the case is deformed.
Doing so may cause malfunction or failure of equipment.
Please insert the battery in the correct orientation.
If you insert the battery in the wrong direction, it may
cause failure of equipment.
Do not use this product at Countries did not obtain
the wireless device certification.
The acquired wireless certification of this product is
described on page 7. Do not use this product at out of
applicable countries.
SENSOR
 To perform a right measurement, do not soil the ambient light
sensor portion or do not cover the ambient light sensor portion.
 To perform a right measurement, do not block up the hole of the
humidity, temperature, and pressure sensor part.
2
INTERNAL BATTERY
 Please use the following batteries.
 In the low temperature environment, the battery usage time per
one charge decrease.
Coin Type Primary Lithium Batteries CR2032
DISCARDING
When you discard, please remove the battery from equipment, and
follow the laws and regulations.
Bluetooth ®
The operating frequency band of this product is used by industrial,
scientific, consumer and medical equipment including microwave
ovens, premises radio station for identifying mobile units used in the
manufacturing lines of plants (radio stations requiring a license),
specified low power radio station (radio station requiring no license)
and amateur radio station (hereinafter referred to as "another
station").
1. Before using this product, confirm that "another station" is not
being operated nearby.
2. In the event of this product causing harmful radio wave
interference with "another station", promptly change the
operating frequency or stop radio wave emission by turning off
the power, etc.
Introduction
This product is equipped with six sensors (3D accelerometer, 3D
gyroscope, humidity sensor, temperature sensor, pressure sensor,
and ambient light sensor), it is a SENSOR LOGGER that can
wireless communication by Bluetooth Low Energy. It is available
periodically sends the sensor data in real time by using
advertisement packet of Bluetooth Low Energy and it have a
function to save sensor data to internal memory. Also it supports the
connection of Bluetooth Low Energy.
, H S, NH , SO , or NO) Part Names
2 2 3 2
Ambient light sensor
Humidity and temperature sensor
Pressure sensor
Humidity and temperature sensor
Pressure sensor
CAUTIONS
Power Indicator LED
(Red)
Battery cover
Power SW
BD address
QR code
(BD address)
3
Z
Y
Ω
Y
Ω
R
Ω
P
Direction of detectable accelerations / magnetic fields
Usage
Use for the first time
The internal battery at the time of purchase is for testing. Please
use it after exchanging with a new battery.
Coin Type Primary Lithium Batteries CR2032
Battery replacement
1. If you slide the battery cover with firmly pressing the two parts of
the cover, you can remove the cover. At the first time, it may be
hard to open the cover.
2. Please remove the old battery from the battery holder by using a
thin tip like a ballpoint pen and replace with a new battery. The
orientation of the battery is as shown below.
3. Please close the battery cover.
4
X