The serial number of your machine is located on the lower half of the steering column of the machine. AS OUR POLICY IS ONE OF CONSTANT IMPROVEMENT - ALL INFORMATION AND SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE. - 2 - TC-CRZ-OP-EN...
An open fl ame or spark can cause this gas Do not use fl ammable materials in Tank or pick up. to explode. Serious personal injury or property damage could occur. Only charge the Batteries in this machine in a well ventilated area. - 4 - TC-CRZ-OP-EN...
Page 5
Do not operate this machine if any parts have been controller. damaged or removed. CAUTION To avoid damage to the electronic control components of this machine, Do not store this machine outdoors. Do not pressure wash this machine. TC-CRZ-OP-EN - 5 -...
CHINE IN A WELL VENTILATED AREA. USE ONLY DISTILLED WATER IN THE BATTERIES. USE ONLY THE OEM CHARGER PROVIDED WITH THE MA- CHINE. ALWAYS DISCONNECT THE BATTERY BEFORE SERVICING THE MACHINE. REFER TO MANUAL OR CALL +011-262-681-3583 - 6 - TC-CRZ-OP-EN...
10. VACUUM HOUR METER - Indicates total hours the vacuum motor has been used 11. DIAGNOSTIC CODE - Displays diagnostic code which helps troubleshoot issues 12. ERROR WARNING SYMBOL - Indicates when there has been a diagnostic code error TC-CRZ-OP-EN - 7 -...
fl ow from the blue hose. Indicates service required. 21. SUDS DRAIN: 22. ZERO3 FILTER: 23. BATTERY DRAIN: Drain detergent from Suds Optional Z O3 (O3+) Ozone Drain any fl uid from Poly reservoir. System Solution Filter. Battery Box. TC-CRZ-OP-EN - 11 -...
O3 CONTROLS (OPTIONAL) 100% - Yellow/Green Lights ON O - OFF 65% - Green Light ON Turn regular solution OFF, when using Z Aqueous Ozone. - 14 - TC-CRZ-OP-EN...
MANAGER LOCK OUTS (OPTIONAL) CONTROLLING MANAGER LOCK OUTS: When the key is in the LOCKED position, keys can be removed and Solution OR Down-pressure cannot be adjusted. UNLOCKED LOCKED TC-CRZ-OP-EN - 15 -...
If battery acid gets on your face or in your eyes, fl ush the area immediately with cold water and Batteries are a possible environmental hazard. Consult seek medical attention. your Battery supplier for safe disposal methods. TC-CRZ-OP-EN - 19 -...
Do not park this machine on ramps or slopes. Always park this machine on a level, hard surface. Do not operate this machine outdoors or on uneven surfaces. WARNING Understand the dynamic braking system before you operate the machine on ramps. Machine may coast. - 34 - TC-CRZ-OP-EN...
Please refer to OEM Charger Operating Instructions for more information. Onboard / AGM / International Chargers: AC Power: 80-270VAC / 50-60Hz DC Power OUT: 36VDC / 33A Please refer to OEM Charger Operating Instructions for more information. TC-CRZ-OP-EN - 35 -...
MODEL 29'' MODEL 33'' BRUSHES CYLINDRICAL CYLINDRICAL LEVEL Tough Grit 276-697S 316-697S High Midi Grit 276-697C 316-697C Medium Light Grit 276-697PS 316-697PS Moderate Fine Grit 276-697F 316-697F Light Nylon 276-697N 316-697N Light Tampico 276-697T 316-697T Light - 36 - TC-CRZ-OP-EN...
Page 37
Squeegee blade kits include (1) Rear Blade & (1) Front Squeegee Assemblies (complete) listed above all come Blade. with Linatex blades. NOTICE Size is stamped into the top of the painted steel squeegee body on all squeegee's. TC-CRZ-OP-EN - 37 -...
P&G CONTROLLER COMMON ERROR CODES Below are common diagnostic codes and some typical causes / remedies. If the information provided in the "Correction" section does not cure the code, seek technical support from your local authorized RPS Corporation distributor. Diagnostic Code Cause Correction 1501 Parking brake is released or the parking brake coil...
Page 39
BLANK THIS PAGE WAS INTENTIONALLY LEFT BLANK...
Need help?
Do you have a question about the CRZ and is the answer not in the manual?
Questions and answers