Silverlit OP ONE Instructions page 3

PROGRAMMING
Three programmed motion patterns can be saved for later playback. The directional control joystick will be disabled while in programming mode.
Programs can be replaced by recording a new one.
Slide the Program Selector (1) Switch to one of three positions.
1
Press and hold the Program Button (2)
2
OP One will make a sound to indicate that he's ready to receive commands
3
Use the Controller to move the head and arms to a position.
4
After each movement, press the Playback/Confirm button (3). The Controller will issue a sound to confirm.
5
Enter more movements following steps 4 and 5, above.
6
Up to 30 movements may be recorded in a single program.
7
To end, programming, press the Program Button (2).
8
• Movements of OP One along the floor cannot be programmed.
• OP One can be driven while a program is being played back.
• A voice recording (see below) can also be played back at the same time.
PLAYBACK:
Slide the selector to the desired program.
1
Press the Playback/Confirm button (3).
2
IDLE MODE
After 15 seconds of inactivity, OP One will make a sound or
action while waiting for his next commands. This will repeat
until 3 minutes have elapsed after which the robot will go into
a battery-saving sleep mode.
When the Controller is set to Automatic Mode (green lights),
OP One's sound detection feature is active. When he detects a
sound, he will exit Idle Mode and respond.
To reawaken OP One, slide his power switch to OFF and then
back to ON. You may need to repeat the pairing process
between OP One and the controller.
VOICE RECORDING
The user can record a message that can be played through OP
One's speaker.
RECORD:
Push and hold the Record Button (1)
1
Speak into the microphone (2). It can be closed or extended.
2
Release the button when recording is complete.
3
• A recording can be up to 30 seconds long.
• Only one recording can be stored at a time.
• Recording a new message erases the old one.
PLAYBACK:
Push the Playback button (3) to play back the recorded
1
message.
Adjust the playback pitch using
2
the Voice Modulator dial (4).
There are five different settings.
DANCE MODE
OP One has several pre-recorded dances.
• There are five pre-programmed dance routines that OP One
can perform.
• Select the dance routine by pushing on the Dance Mode
button (circled) the proper number of times. (see table, right)
• End a dance routine by pressing the Dance Button twice.
Dance 1
Dance 2
Dance 3
Dance 4
Dance 5
LISTENING MODE
OP One can listen to sounds in the room and transmit them back
to the speaker on the controller.
Press the Listen Button (1)
1
Any sounds picked up by OP One will play out of the Speaker (2)
2
Press the Listen Button again to exit Listening Mode.
3
• To avoid feedback, keep the remote at least five feet away from
OP One while it is in listening mode.
1
2
3
4
2
3
# of presses on
dance button
1
2
3
4
5
AGES 8+
1
1
2